Project rebuild....

[karl_tate]

well still trying to find out these little problems, took it for a longer drive and the blue/oil smoke has cleared which i had hope would. still fuel smoke when revved though.

ive been over all the wiring and sensors, the only other thing that i have changed is that i dont have the dash in, now weather its some sort of sensor/input i dont know :Hammer :xconfused


took the plugs out but i was expecting them to be bad from moving the car back and forth moving cars around on the drive.

first pic is the trailing, the plug on the right being the front rotor in both pictures.







and another little vid

[karl_tate]

any one got any input??

btw in the vid i put 9\'s all round.

[shaunwil]

Shouldn\'t they look like a crowns head at the probe end ?

Shaun

[karl_tate]

on the 7 and 9\'s for the rotary yes, but ive never seen racing 10 and 11\'s until now as these are just what pip put in??

[BlitzBoy]

Its running RICH dude

[shaunwil]

on the 7 and 9\'s for the rotary yes, but ive never seen racing 10 and 11\'s until now as these are just what pip put in??

Ah right, I\'ve got the same plugs then :Giggle !

Shaun

[karl_tate]

yeh, i was thinking they would of been the same style.

are you saying that because of the video or the plugs mark??

[BlitzBoy]

plugs for defo and the video shows it blowing a blackish darkish smoke, maybe the temp correction settings on the map is adding too much fuel for these low ambient temps we are having at the moment

[kev_coupe]

just read through all 11 pages and your build is an inspiration!

Keep up the good work

[manux86]

Hi, there\'s a particular way to reassembly the crank angle sensor plate? I don\'t know how can I do that for right ignition timing.

[karl_tate]

well i knew the plugs were gong to be a mess with just moving the car around, will take it for a little drive with the 9\'s in, take them out and see what they are like. any idea why it sounds like a bridge though??

cheers kev, im glad you enjoyed the read :Thumbs-up


if i remember, the crank plate can only go on one way.

[manux86]

if i remember, the crank plate can only go on one way.[/QUOTE]

But the pin don\'t must going aligned with the mark?

[karl_tate]

im not sure what you are trying to say, maybe this picture helps??

[manux86]

excuse me for my english..I\'m Italian..

[karl_tate]

no worries, your english is better than my Italian. yeh thats right, once you get the plate in your hands and put on engine you will see hope that helps.