Doing the non-seq conversion.. help me lol

[interloper393]

Right here goes im going to follow the first pic diagram for the non-sequencial conversion on ma 97 spec rx7, from what iv read it shouldnt be 2 bad and im hoping to remove everything i can, simplify everything, so when the day fer a rebuild comes its guna be alot easyer.. hoping to go single but until the right tubby comes along im going with this.. shud make the single conversion easyer anywho lol..

SOOooo.. tomorrow it begins.., iv removed alot already trying to find a boost leak with no joy..

Is there anything i cn do to make them less laggy or will they still boost at 1500rpm? heard mixed reactions on these..

:wave

[rico2k_uk]

you doing the poor mans  version? if so, make sure you give a good writeup!:D

[Teighto]

2nd ^^^

[interloper393]

im going the full hog... all or nothing im affraid guys

[Jimjitsu]

you wanna borrow the van of destiny?

[interloper393]

nah just u n john lol.. did u just rip all the nest n vac hoses out n start fae there? is diagram 1 guna do the job lol

[rico2k_uk]

well, once you have finished practising on your car.. i might take a drive up to ayreshire

[Jimjitsu]

well i ripped it all out apart from one that goes to the fuel regulator i think best to ask john because thats what i did lol pretty sure diagram 1 is what we had dont mind helping if you wanna bring it a bit closer to where we live :driving

[John_Hudson]

Diagram 1 is the puppy i used, just keep the vac line from the purge control and you can re route the FPR vac line to the nip that faces towards the firewall ( its the only one ) down between the injectors.  Everything else is as shown.

are you okay for grinding / welding stuff up?

I happen to have a manifold that has mostly been converted, it only needs to be cleaned up all the welding and grinding has been done.

I also have the other bits but we never got around to finnishing that part of the conversion due to jims primary being shagged

[interloper393]

iv hit a dead end... nothing really matches with the black box mines got,all the plenum pipes are different :S

Im ok welding n grinding

[rico2k_uk]

lol! like i said, this is your practise run to get it right before you have a go on mine

[John_Hudson]

iv hit a dead end... nothing really matches with the black box mines got,all the plenum pipes are different :S

Im ok welding n grinding

can you put up pictures?

[interloper393]

will do bud, damm this new age car lol.. was all set to start ripping it all out

[John_Hudson]

id pull it out anyway if it was me :p

[interloper393]

here ya go m8, the plenums nothing like a earlyer one with the nipples.. already removed the butterflys n ported it lol...

Think im at the stage where if i just rip it all out then it`ll be easyer..