MX-5 NC with RX-8 231 Engine

[Paul_13]

Any body know what the relay is for where my finger is pointing?

Sent from my SM-G965F using Tapatalk

[Paul_13]

Any body know what the relay is for where my finger is pointing?

Sent from my SM-G965F using Tapatalk

Air pump relay.... Will be leaving that out. Wish I would double check things before ordering stuff. Got a pointless relay on its way in the post

Sent from my SM-G965F using Tapatalk

[Paul_13]

Well good news, everything on the abs and EPS is correct wiring wise.
I've done a continuity test on all the EPS cables and torque sensor, all OK
Just waiting on electrical contact cleaner and abs sensor wire.

I double checked the abs sensor wire and no continuity which is strange, must of got damaged during swap

Sent from my SM-G965F using Tapatalk

[Paul_13]

Finishing touches

Sent from my SM-G965F using Tapatalk

[Paul_13]

Taa daa

Sent from my SM-G965F using Tapatalk

[boosted]

Lol like it .

Sent from my SM-N950F using Tapatalk

[Casey]

  Yeah, nice finishing touch 

[rote8]

Likewise nice finishing touch prmoting rotaries.

[Paul_13]

The earth cable was quite corroded on the EPS so hopefully that issue is sorted. Gave all the other connections a blast with contact cleaner.
New abs sensor wire is on.
Ready for a drive tomorrow

Sent from my SM-G965F using Tapatalk

[Casey]

Test drive   

[Paul_13]

A proper one this time

Sent from my SM-G965F using Tapatalk

[Paul_13]

@boosted did you have to do anything to the map to make it run properly on one lambda?

Sent from my SM-G965F using Tapatalk

[boosted]

Hi mate no i didnt just got the code for it...it wont effect anything or it shouldnt...all the 02 sensor does is monitor cat efficiency...post and pre cat 02 sensor are different worth checking youve not swap them...
Whats happening? New engine expect some flashing cel misfire for a few hundred miles...

Sent from my SM-N950F using Tapatalk

[Paul_13]

Just prempting.
I did take for a short drive the other day and I've zero'd out the dtc's for air pump. Cat efficiency and rear o2 sensor codes.
I've set rpm limiter to 4k.increased oil injection rates slightly across the board.
Changed the dwell timing settings for d585 coils.


Sent from my SM-G965F using Tapatalk

[Paul_13]

Fitted these, I honestly thought they were a joke when I first saw them. But now I understand why they're needed!

Sent from my SM-G965F using Tapatalk