rebuild parts list

[craig]

Hi all
I would like to rebuild my 93 fd i have had it sat on the drive for some time,and thought i would give it a little go .
I have a small list of parts i need but would like  a full list  of every bit needed.
i did a search of the site and could not find anything.
plus is there any website that sells the parts ?

thank you for any help
Craig

[davehg]

some of it will depend on the condition of oteer parts in the engine such as rotors, rotor bearings etc etc

[craig]

ill sort them as it comes to bits ,just wanted a parts list just to get it going.if anything else is in need rotors ect  then ill get them as i go.Not in a rush to fix it,as its been sat on the drive for 2 years,just want to play around with it now if it all goes wrong then well not lost anything.
:0)

[m1tch]

Try and get/borrow a rebuild video are you going to rebuild it to OEM specs or race specs?

[craig]

just to the specs it came from mazda with,it does have a few new bits on it  intercoler and feed air intake and a feed exhaust,nothing to worry about i don\'t think.
Ill have to find a dvd ,will be nice to have a video of how to do it.

[m1tch]

check out pineapple racing:

http://www.rebuildingrotaryengines.com/

they have some free rebuild vids and stuff to show u some of it

[craig]

Thank you  that is a very good site,i will get the video\'s and look for a rebuild kit .

[karl_tate]

hi craig, hope you good.

if your wanting to do it your self get the rebuild dvd, some one on here might send you a copy, ive been trying to find some one

i lost a tip around 2 months ago and i got my rebuild kit from pineappleracing and my builder rated it very highly.

[mjwebb48]

Dragon have always got everything in stock  at all times as i believe he supplies most of the other tuners with the bits I would have though he`s prob the cheapest as well.
Give Ross a ring 01404891888 say matt sent you.

[BlitzBoy]

You can get heavy duty gasket (Viton) kits better and cheaper from Gary at Rotaryarts, you can even reuse the water seals in his kits

[Cooch]

Ive been looking at doing this aswell and im gona for new housings just as a peace of mind thing but other than a rebuild (seal kit) and some new apex seals is there anything else i need?

[BlitzBoy]

Dragon have always got everything in stock  at all times as i believe he supplies most of the other tuners with the bits I would have though he`s prob the cheapest as well.
Give Ross a ring 01404891888 say matt sent you.

Yes I got a new front plate from Ross , he was very quick to supply :Thumbs-up

[Cooch]

Blitzboy thats where i was gona get my seal kit from-bout £125 arent they?
 
As found at the top of this page.
 
http://www.rotaryart.uk.com/acatalog/RotaryArt_engine_kits_for_Mazda_RX7.html

[BlitzBoy]

yes they are , I have seen these in the flesh very good quality, wish this was available earlier when I did my build, the seals help stop blow by at high boost, and are actually used by a few top rotary drag racers abroad

[Cooch]

So if i had that seal kit mentioned above, some new housing, some Hurley Apex seals what else would i need?
 
Side seal kit and some corner seals?