Messages

Is the commander accurate, or is it a bit behind when showing the value?

So not the best fit then, are there other gauge pods that you would recommend, i know of tripod and FEED.

I know some are not so good, like melting when in hot weather.

I know, i have the ECU installed, just at the time i did not really need the commander.
What gauges can it act as:

Boost, water temp, oil temp, etc?

No worries i found out what it can tell.

I know, i have the ECU installed, just at the time i did not really need the commander.
What gauges can it act as:

Boost, water temp, oil temp, etc?

Thanks BlitzBoy,

Is it suitable for upgrading as well, so if i get a single turbo and it starts running harder, is the commander able to handle the upgrades?

Thanks Jono, much help. I will get looking!

I am thinking of using the Apexi commander to act as a gauge for the boost and water temp

Do you think this is a good idea?

Is there a blub that can replace the original that is much brighter if i wanted a cheaper solution for the time being?

Thanks Jono,

I really like the look of the re-amemiya ones, but have also seen the twin light pop ups which look good.

One thing about the RE:A i heard is the standard bulbs are not so good, so it is worth getting higher bulbs, but this can get put more pressure on the wiring kit. Don\'t know too much about it and haven\'t seen them in action to tell.

The round ones

There maybe a thread on this already, but i am looking to upgrade my headlight from the stock, i know there is a range of types, but anyone got an suggestions on what is the best. I know some are good, but may require a a bulb upgrade.

Its for a 94 FD.

Thanks

Has anyone got a RotaryArt Carbon dash pod?
Interested in getting one, would be good to get feedback on them, as well as knowing if the 2 or 3 pod would be best.

Thanks guys, i have done it now, i took my time, hopeing not to break any clips, and fortunately did not rip my hands

Hi MaLice,

That is what i thought! Thanks

I am looking to remove the center air vent above the heater controls, what is the best way to do this?

Am i right in saying there are 2 screws holsing in place as well as the clips.

Thanks