Japi's FC T2 Convertible

[boosted]

Keep it up mate ...getting there...

Sent from my SM-N950F using Tapatalk

[kev-yorks]

What's your manifold made of Jarno, from experience if driving hard wrapping the manifold isn't a good move as it holds too much heat there leading to failure. I normally coat and heatshield only pre-turbo and then wrap post turbo on the downpipe.

[re japi]

What's your manifold made of Jarno, from experience if driving hard wrapping the manifold isn't a good move as it holds too much heat there leading to failure. I normally coat and heatshield only pre-turbo and then wrap post turbo on the downpipe.

Its "black" water line pipe. Really hard and thick wall stuff. I think its 3mm. Some local guys here uses it alot. Cheap, and tough.

Well, yesterday when I run out off that new wrapping, I thought I could do "half warp" to manifold. This manifold was used and made by my friend and it was ok. He used it about year. However, my biggest consern is how to flush hot air out of the engine bay...

Do you have pics from yours?

Lähetetty minun G8141 laitteesta Tapatalkilla

[re japi]

I was a bit bored at work yesterday so I made a built sheet of my car:

-Oem/Mazda gaskets and seals

-RX-8 LP E-shaft
-RX-8 HP gearings
-racing bearings
-Mazdatrix thermal pellet
-FD oil regulator
-5mm Baffle plate
-EGR block off

-Pineapple racing bridge port with larger primarys
-Pineapple racing EP4 exhaust port, modified to 4 mm wider, opens and closes faster
-Ported and polished intakes

-Turbosmart Boost Tee
-Turbosmart FPR 800 fuel pressure regulator
-Turbosmart Vee Port Pro blow off valve
-Greddy intake elbow
-FMIC, Greddy copy, Spec LS

- 2 x  EV14 957cc injectors
- 2 x  EV14 1300cc injectors
- 4 x  IGN-A1 coils (same as AEM without sticker)
-Fuel pressure sensor for ecu
-RaceWorks ”bolt on” fuel rails

-Switcher S300 hybrid with 60mm/68mm 1.16ar
-Custom header with massive screamer pipe
-60mm Tial wastegate

-Aeromotive A750 fuel pump
-Surge tank

-Extremeclutch KMZ24004-1B (Stage 4/670nm)

-Adaptronic PnP

Thats basically it. Ofcourse list doesent have all the little stuff, and its still not ready...

[re japi]

Time is running out...

Well, yesterday I hadnt had time much for FC. I hade to make my campervan ready for weekend...

But I had some time. To realize that stock radiator and cooler I have, wont fit. Like, no way to go with these...

Also, I have to pull apart fuel rails. I dont like how they fit with injectors. Bolt on parts, my arse...

One step forward, two step back

Lähetetty minun G8141 laitteesta Tapatalkilla

[boosted]

Rome wasnt built in a day mate...right first time policy...
Youve got a camper van ?

Sent from my SM-N950F using Tapatalk

[Jamie R]

Rome wasnt built in a day mate...right first time policy...
Youve got a camper van ?

Sent from my SM-N950F using Tapatalk

Swap the VW engine out for a Subaru Flat 4

I heard those Subarus make good cars ya know lolllllllllll

[boosted]

Im interested to know what camper hes got..i bet its got a big fridge for all the beer...
Mazda Bongo?

Sent from my SM-N950F using Tapatalk

[Jamie R]

.... this is on his FB page lolllll  joking

[re japi]

Lähetetty minun G8141 laitteesta Tapatalkilla

[re japi]

I have - 97 Fiat Ducato based short Euramobile.

Got it last august. Realized that I have to have one cause, last year we, me and bro travelled quite abit in rallycrosses, and sometime we had kids with us

And yes, there is decent amount of space for beer

Lähetetty minun G8141 laitteesta Tapatalkilla

[Jamie R]

Jarno where are you?...

[re japi]

Im here, just been really busy...

Lähetetty minun G8141 laitteesta Tapatalkilla

[Jamie R]

He's alive !

Hey bud 

[re japi]

Yep... Rallycross season takes all my spare time now... I can continue car build when I have summer vacation. Starts June, two weeks

Lähetetty minun G8141 laitteesta Tapatalkilla