Would appreciate some help!

Started by Dan.R, March 03, 2012, 09:11:48 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

Dan.R

Well, my insurance ran out early February and was going to leave my rx7 stood until 28th march when im 21 as it\'ll go down... I started it up every saturday and it was fine..

I started it up yesterday and it was its usual self but then it suddenly went a lot deeper sound, almost sounds like its misfiring, (was low on fuel at the time).
I thought it may be an issue because it is low on fuel, added £30 and its up to quarter, i drove it up and down the road, (sensibly lol) and its lost most if not all power. The sound is REALLY deep and idles completely different. The idle before was like it was hunting, like a cammed idle and now its sits at just under 1K and is completely flat.

She does have a few mods on her, like Apexi PowerFC, Dragon performance Pulley Kit, Gt 35 Single turbo conversion, Blitz Dump Valve, Big Aluminium Front mount intercooler, Big aluminium Racing Radiator, 850cc primary and 1600cc secondary injectors, Turbo Smart 38mm External Wastegate, FSE Fuel Pressure Regulator & Uprated Fuel Pump.

As i said earlier in post, RX7 has lost most if not all its power, doesnt feel like it even has 200BHP. No smoke at all, Engine has no knocking and doesnt sound like a diesel...

Also the FSE fuel pressure regulator was making a high pitched whine, but that seems to have stopped now...

Could i have caught something on the PowerFC? is it spark plugs? Im genuinely gutted :(

Will appreciate any help at all!

Brett

Check the following:

MAP sensor hose connected
Plugs not fouled

:wave
Brap Brap Brap Brap

Dan.R

Quote from: Brett;814734Check the following:

MAP sensor hose connected
Plugs not fouled

:wave

Thanks for a quick reply!

Where on earth are they? :xconfused

Brett

IIRC the map sensor is on the rear bulkhead of an FD, should have one hose and one electrical connection.

I hope you already know where the plugs are... :Giggle
Brap Brap Brap Brap

Dan.R

Quote from: Brett;814736IIRC the map sensor is on the rear bulkhead of an FD, should have one hose and one electrical connection.

I hope you already know where the plugs are... :Giggle

Just went out and checked the map sensor, its all fine (well looks it) nothing loose.

Funny thing is, i have no clue where they are, looked for a good 10 minutes and cant see a thing! its just so cramped and everything is like in layers! haha

adib

plugs are half way down the engine on passengers side

HaywardRotary

I think that the wastegate is stuck open.Check if you are making no boost or less than before.
I have had this happen on Turbosmart before quite a few years ago so from then on I only use Tial wastegates and have never had the issue again.
Regards
Carl
We warranty our rebuilt engines for Detonation, track day\'s and RWYB and NOW for 30 months which is two and half years or 30,000 miles
We also build all types of race or road engines.
We build race and track cars too.
Any kind of porting undertaken.
Single turbo conversions.
S

a.tapos

Check the boost pressure on hand commander whilst under load,Does it rev ok stationary ?
red 93 t88 half bridge fd project,black 1993 fd
a.m.t@hotmail.co.uk

Dan.R

Quote from: adib;814829plugs are half way down the engine on passengers side
Thanks! Found them! Damn there a pain to get to :2Rolleyes

Quote from: HaywardRotary;814832I think that the wastegate is stuck open.Check if you are making no boost or less than before.
I have had this happen on Turbosmart before quite a few years ago so from then on I only use Tial wastegates and have never had the issue again.
Regards
Carl
Okay, thanks for that! how would i check the wastegate is open?

Quote from: a.tapos;814837Check the boost pressure on hand commander whilst under load,Does it rev ok stationary ?
Yeah ive got a boost gauge, it all looks fine, it was flashing a couple of days the rx7 went like it has... It revs slowly compared to normal... Takes a little longer to rev down as well after letting go off gas...

Thanks to everyone! really appreciate the help. Im a total noob when it comes to rotary lol.

Dan.R

Engine has been looked at by Rotary specialist and has "blown a tip".

Anyone know how much roughly it could be sold for as it is? Been quoted £2K to fix and was wondering if it was worth it to spend that or sell it as kinda need the money to get another car...

Below is spec and pics, any estimates would be appreciated!


1995 (M Reg)
41000 Miles (Up to 32000 was in km)
Type Rb
3 Months Tax
10 Months Mot
Recently resprayed in Volkswagen Sirocco Green, has a lovely sparkle to it.


Engine

Twin rotor 1300cc 13B Rew
Dragon performance Pulley Kit
Gt 35 Single turbo conversion(32000 miles)
Blitz Dump Valve.
Big Aluminium Front mount intercooler.
Big aluminium Racing Radiator.
850cc primary and 1600cc secondary injectors.
Turbo Smart 38mm External Wastegate.
FSE Fuel Pressure Regulator.
Uprated Fuel Pump.

The engine is running impressive 385bhp and 500nm torque at 0.8 bar of boost

Other

Greddy Single Plate Racing Clutch
5Zigen Straight through 3" Stainless Exhaust.
Uprated Front and rear anti roll bars.
17" advan wheels powdercoated steel grey.
New battery within last month

Interior

Oil Pressure, Oil Temp, Water Temp, Boost Gauges.
Aftermarket Speakers Install and Custom stealth 2x10" Subwoofers.
Kenwood Head Unit Cd/Radio
Carbon Cloth effect seats
Racing Steering Wheel and Boss
Sterling Cat 1 Alarm /Immobiliser
Has a Apexi PowerFC hand held unit in car which is mounted securely and looks like it is ment to be part of the interior








grinder

i suppose the only way to work out what to do is work it out

If you rebuild it - whats its worth 4.5K ?? ( dont ask me i have no idea )

So its 2k to rebuild .. would you get 2.5k as it stands now ( to be honest , i dont think you would ?? )

So lets say its worth 1.5K now ( as its got a single etc. ) , could you get it rebuilt and sold for more than 3.5K - yes i think you could

Sooooooo in locigal terms , spend the 2k and rebuild it to get a better price to sell it


1990 Black Turbo II ( Updated 24th October 2006 ) : Click Here !!
1991 Turbo II Cab ( Updated 21th May 2009 ) : Click Here !!
Piccies >>> July 2004 / August 2005
My Feedback Thread: Click Here !!
Official Mazda Rotary club Tight A$$ :King (So tight only dogs hear him fart)
MRC Bargain Hunter 2005/6/7/8/9/10/11/12/13/14 :god
Inventor of the 96p car cover:D
**Special award for services to tightness**
Lifetime achievement award for services to tightness
The tightest man on earth
:Giggle

turbo boy

Lets be honest here, no one is buying 17yr old mazdas. To spend £2k on it in the hope your gonna sell it for £4k is a pretty big gamble. Never thought i`d steer someone towards breaking an fd, but if you want some money from it that`ll be the best option.
 But do try and sell it as it is. Its easily worth £1500

boosted

Where abouts are you? Whats happening with this car..........
92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.

scottc1088

may be interested depending on location

Dan.R

Thanks for all the input...

Ive put it on piston heads for 2.5K, had quite a bit of interest and a couple of viewings booked already!

im located in Dorset for any interest from here...