out with the old in with the new

[steve garbutt]

Well most of you will know the PP motor has been pulled from my car as i couldn\'t keep funding it.
So in went a street port, motor has now been run in on stock twins and fairly stock mods, so now its time to start to mod it again

1st up is an excessive lim

[steve garbutt]

Next is a nice new thermostat housing.

[steve garbutt]

Then a polished UIM and rather large Throttle body.
Second butterflies yet to be removed.

[steve garbutt]

New Filler neck yet to be powder coated and catch tank.

[steve garbutt]

More Bit to come including a t61 small single turbo.
Hopefully its going to be a quick build

[memski]

Cool, I\'ve got the xcessive setup to go on too. Where did you get your rail fittings from?

[steve garbutt]

Got them second hand so came with the lim unfortunately.

[memski]

Np, got the injectors so just need to get the fittings and I\'m good to go. Nice bit of kit isn\'t it?

[steve garbutt]

Yes fantastic piece of kit
It wouldn\'t be hard to make a fuel rail, the fuel rail you can buy to length then its just a matter of tapping both ends and drilling the holes for the injectors.
There are drills available specifically made for drilling the holes for injectors.

[probedb]

Looking very nice Steve, I\'ll have to have a nosey next time I\'m in

[fil_auto]

looking interesting and exciting too

[steve garbutt]

looking interesting and exciting too

Hopefully it will be a little different

[steve garbutt]

Started working on the uim
I know there are a lot of arguments for and against.
this is the uim just after removing the butterfly\'s and the big hole it left

[steve garbutt]

This is after bunging the hole and a little bit of porting of the uim.

[steve garbutt]

After tapping and popping a bolt in the hole in the side of the uim by the butterfly\'s, i then made a blanking plate so it cant work its way loose.