Single turbo conversion, old rats nest!!??

[7gabbo7]

hello guys, i am quite well on with my single turbo conversion and was wondering if anyone could answer a few questions?
the old plugs from the rats nest, do these get taken care of during remapping or do i need to link them out?(dead short them?) also airpump and boost sensor plugs, what do i do with them?  
advice will be greatly appreciated.Darren

[slingo]

if you use apexi they ignore the fact there not connected where as standard e.c.u will fall into limp mode !
 
you can make a custom loom or just leave the plugs dangling

[7gabbo7]

for tidyness sake i would like them gone. running a standard ecu at the minute can i just cut them out and get the ecu remapped? do i have to keep any of the solenoids connected from the original twin turbo setup? ie fuel pressure regulator solenoid? cheers

[marco]

err if you are going single turbo you are going to need a new ecu. the apexi connects straight into the loom, and you can cut out the connections you dont need without sticking a resistor in, but make sure you keep the ones you do need!

[slingo]

if your using standard e.c.u leave the solenoids connected but not plumbed in ! if you drive it id get a wideband it dosnt take much to max your dutys oh and a decent fpr but stic\\k with low boost until you can get your over bits

[7gabbo7]

does anyone have the fuel pressure regulator solenoid part number?