Engine in and nearly ready.. a few plugs left, where do they go??

Jim_rx7 · February 13, 2009, 03:38:23 PM

Ok... I have the oil pressure sender - unsure where that plugs into
Also the little connector underneath it (water temp?)
Finally the sensor on the sump.. also unsure where that plugs into.

Appreciate any help here chaps... nearly done!

trotter · February 13, 2009, 04:39:44 PM

The sensor on teh sump attaches to the loom just to the right of the block (if you\'re looking at the bay from the front. Its about half way down the side

Jim_rx7 · February 13, 2009, 06:47:13 PM

right. Think we got that one sorted. Also oil pressure also working fine.

Only thing that\'s annoying me now is the coolant buzzer is on all the time!?

So obviously somethings not quite right?!? LOL

The plug from the water filler neck is plugged in. Is there another that would do the same??

Bob Monkhouse · February 13, 2009, 06:56:09 PM

I might be able to answer that one as I did the same thing. As long as its got the correct water level then you may have put the wrong wire onto the level sensor, offhand I can\'t remember what colour the two confusing wires are but they could both be black. Look for a wire that will reach the sensor and swop them round, hopefully it will stop buzzing.

Jim_rx7 · February 13, 2009, 07:13:14 PM

Is the other water sensor the one under the oil pressure sensor?

Jim_rx7 · February 13, 2009, 07:15:58 PM

What plugs onto the little plug under the oil pressure sensor?? I took a plug that came from the main engine loom. More or less at therop of the gearbox.

Jim_rx7 · February 13, 2009, 11:29:39 PM

Done a bit of reading etc and it looks like the oil pressure sensor and water temp sensor are defo correct.

Something oviously isn\'t! Doh

Laeeq · February 13, 2009, 11:37:00 PM

it is water temps sensor.

Laeeq

Jim_rx7 · February 13, 2009, 11:47:51 PM

I\'m gonna have a good hunt about tomorrow and see what I can find/swap about etc and see if I can get this buzzing to go off!

BlitzBoy · February 14, 2009, 12:10:13 AM

Quote from: Jim_rx7;584313Is the other water sensor the one under the oil pressure sensor?

no I think thats the knock sensor, take a pic

Jim_rx7 · February 14, 2009, 10:20:21 AM

Knock sensor lives near the front of the engine above the front set of plugs.

At the back there\'s the oil pressure sensor (which is connected fine) and a little sensor undearneath it. (water temp?) - that one is also connected as there\'s really only one place for it as there\'s a little connector that comes right off the loom there.

Jim_rx7 · February 14, 2009, 03:26:28 PM

Ok.. I know roughly what connector should be connected now (I think it\'s actually broken off - hence why it\'s not connected!!)

dturpin · December 05, 2009, 10:52:43 PM

Hi Jim
I was wondering is you managed to sort this out as I am currently having the same problem with my car after putting the engine back in.
Cheers
Dave

Jim_rx7 · December 08, 2009, 11:20:34 AM

Yeah, I sorted it.

What were you having issues with?