BOV Vacuum line help!

Started by DMDRIFTING, December 13, 2008, 05:00:52 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

DMDRIFTING

Hello again,

below is a picture of the intake plenum on the FD, the two blue vacuum lines run from the twin BOV\'s (Bought the car like this).

What i would like to know is, are the two vacuum lines in the correct place?

Is there a difference between the lower plenum nipple and the higher nipple \'Positive vacuum etc\'?

Should I \'T\' the two BOV vacuum lines into the upper or lower nipple?

Or leave as they are?

Apologies for picture quality

Many thanks for any help! I\'ve studied the Workshop vacuum line picture briefly! Would be helpful for your advice!

DMDRIFTING

The Charge Relief Valve (Sits closer to the front of the engine) Vacuum line, runs to the Lower Nipple on the intake plenum!

The Air By Pass Valve vacuum line runs to the top nipple on the plenum!


Just found a large vacuum diagram ;)

DMDRIFTING

Correction the Charge Relief Valve sits closer too the bulkhead, and its vacuum line runs to the lower nipple as stated above.

The Air By Pass (BOV) vacuum line runs as stated to one of the top nipples on the plenum :Talking1