Turbo housing\'s

[Fats]

Can I fit a 1.0AR exhaust housing on a turbo thats got a 0.6AR Housing??

Looking at buying a Blower thats the same size as a T04S but with a 0.6 housing, It\'s a garrett 60-1 tub with 0.7 compressor housing and 0.6 exhaust housing, I want to swap the housing off my old tub and save messing about with the downpipe.

Cheers

[Ed_RX7]

as long as its a garrett style front housing and rear housing it should just bolt up mate!

[Fats]

Sound mate, I was more bothered about the size of the turbine, this would\'nt be any smaller if it had a 0.6AR housing fitted would it?

Im stressin out becasue i don\'t want to buy a tub a find it won\'t work with the engine

[Ed_RX7]

well as long as the rear housing is the same trim as your current turbine wheel  then all will be fine in most cases....Most turbos are P trim which is about 64.5mm in diameter......so measure up before you try and fit to avoid possible damage to the turbine wheel during fitting.

[Fats]

Gotcha!!

You\'re a star dude thanks:Thumbs-up