need some help fitting secondaries

[karl_tate]

well i have got some 1600cc or what the exact number is and KG parts fuel rail with fuel regulator
 
basically i would like a little help on fitting :wiggle
 
have taken most of the parts off that i need to get access so i can remove the rail.
 
i have looked at the injectors i have bought and the stanard clips will not fit onto them so what is the best solution??
 
also im sure i have read some where that i need to blank off the acv?? if so where could i get a blanking plate and also why??
 
what other parts do i need to fit including all braided pipes and fittings etc? i can get the braided pipes and fitting free :Laugh  but what size and length??
 
i have read through the guide on RX7club but would just like these few questions answered :p
 
thanks
 
karl

[Jit]

the injectors should come with the correct wiring plugs which you solder onto your loom in place of the old 850cc inj plug. the new rail simply wont fit on with the acv in place hence the need to blank it. Some of the vendors on here should sel the plates.
Did you not buy a complete kit for the injectors? it should include all of that?

[karl_tate]

i may be able to make my own planking plate up then.
 
well i asked rixio to order the injector kit for me whome i bought the car off but only got the above parts.

[arrouk]

karl if you give me a ring or drop me a pm ill help you out with fitting, but im gonna be buisy untill jan now.

matt

[karl_tate]

PM sent matt
 
any idea\'s of where i can get the injector clips??

[FD3UK]

You can buy injector wiring clips from HERE PN 806-658



Check HERE for some useful information and reference pictures.

[karl_tate]

thanks for that site, got some good diagrams for vaccum hoses. although the setup on mine is alot different for some reason.
 
so basically i can use any injector clips that are from a car with bosch injectors??
 
cheers
 
karl