Costs of an FD Engine Build

[Fish]

OK, I am starting to look at building an engine for my FD.

I am looking at having it ported, but to what extent I am not sure.

I will be running the twin turbo setup to start with, then looking at moving to a big single in the future.

So back to the question, how much should I be looking at for a build?

For the tips, I like the idea of the 2mm standard tips, because of the stories I hear about 3mm tips chattering. I understand that the 2mm are not as good at handling det, but a good map(per) should resolve this issue.

If I supply an engine, that is either running, or losing compression that they can rebuild. Then they supply all the parts needed, porting, building and removing and re-fitting.

Thanks

Dan

[Grizzly]

Are you thinking of doing the rebuild yourself or geting it done for you?

I would recomend not to try a Twin turbo engine rebuild if its your first time?

The Twins have lots of pipe work that is not easy to get out and put back (lots of pictures)

Chris

[Mike]

I\'m looking at an engine rebuild similar to yourself but haven\'t decided on a single or twin turbo setup.  Anyway the cost is out of my price range at the mo as I\'ve just got a new house (doh!), so I\'m going for a DIY rebuild. There\'s loads of info out there.

Fish, where abouts in Kent are you coz I\'m also in the same part of the world.

[Fd3BOOST]

I rebuilt mine and ported it aswell.
My cost for all the seals and gaskets was apx. $900 american.
I was lucky and did not have to replace any parts ie. rotors,e-shaft,housings or plates.