Top Hose Water Temp Gauge

[antnicuk]

traders policy!

There is more to come when i get a boost controller!! i would like to run about 1.1 bar and see around 370 at least, fingers crossed!.  
The power FC is bog standard for an FD, runns the stock program and gets mapped like any other FD,  i had the FC wiring loom converted to fit which was fairly easy, although i did also supply and old FD wiring loom to help, ReWorx did this,  You would either need the FD UIM or get Throttle position sensor to work somehow but fitting the FD UIM solves a lot of problems in one go and isnt too difficult to fit,  you get the air temp sensor, TPS and can fit a greddy elbow instead of the stupidly small FC throttle body inlet.

[grinder]

it all sounds well and and good i must admit - thats probably well over the top for what i want to be honest - i was looking for about 250-260 at the fly

and im hoping that will be possibly without completly rebuilding the car

failing that - just a terminal speed of 100.01 mph will do me just fine

[thebandit]

Any plans to do anymore gauge installs?

Im toying with the idea of oil temp/oil pressure/water temp on my Egi.

Where would it be best to take an oil temp feed from and where would i be best to monitor pressure?

[grinder]

you already have oil pressure on the dash - so you could leave that alone

and to run an oil temp - you can get a sandwich plate that lets you do it- i have set up a discount code at a company - but you need to be a member to see the details - sorry

not sure what the next gauge it to be honest - im sure i will find one !!

[thebandit]

Looks like im becoming a full member at the end of the week then  :chat