Custom Gauge Holder

[grinder]

Im in the process of making a custom gauge holder that will slot in above the radio

it will hold 3 gauges

i will take pics as i go along and post them on here

i know you can buy these from the states for about $60 but thats not the point - mine is free

Ta

Stu

( bloody typical - the pics didnt copy to my pen drive - will get pics up tomorrow )

[grinder]

the gauges will be

1 - boost
2 - A/F gauge
3 - Not sure - depends if GMAN cracks and sells me a water temp gauge

2 for defo - but will do a 3 gauge holder

its just looking a bit naff at this moment intime ( althought the better half said it looked OK ! )

pics tomorrow ( if the pen drive likes me ! )

Stu

[grinder]

1

[grinder]

2

[grinder]

3

[grinder]

4

[grinder]

5

[grinder]

6

[grinder]

7

[grinder]

8

[grinder]

9

[grinder]

im now onto the 2nd attempt - didnt like that one

major prob is the 52mm hole to cut - need to do it with a hole saw to make it need

[grinder]

well after a rethink and getting my dad on the case we did a new holder that looks a lot better

and here it is fitted in the car :

[jetpilot]

Snap

[TRex]

Not one to be left out...