Rotang!

[Mr Spiller]

I love the name
First time it's popped into my feed


Sent from my iPhone using Tapatalk

[Jamie R]

So .... This uses 60 degree bent intakes which is an old design.
The principle is the same on the latest design which just uses a 90 degree bend

So we have housings, 2" tubes, IDA flange, 55mm - 50mm itb's, tapered trumpets to a tuned length which will give peak hp at 9000 rpm. Then for lower rpm and to flatten the torque curve we have 100 extension tubes which will stay attached until a set point on the rev range then move upwards 35mm to allow the air to rush in on the lower trumpets.


Sent from my iPhone using Tapatalk

[Jamie R]

https://youtu.be/SnSADk9j7Mg?si=7tf_gXdQmsdau9N0

This vid shows an animation of the moving trumpets which is very common on high performance sports bikes


Sent from my iPhone using Tapatalk

[Jamie R]

Cross section picture shows parallel walled tubes, then the flange, throttle body, first trumpet and extender trumpet is one continuous taper


Sent from my iPhone using Tapatalk

[Jamie R]

Dimensions derived from a universally published SAE paper for PP engines


Sent from my iPhone using Tapatalk

[Mr Spiller]

Word on street is
Your a bit clever


Sent from my iPhone using Tapatalk

[Jamie R]

Word on street is
Your a bit clever


Sent from my iPhone using Tapatalk

I wouldn't go that far ole bean, I'm just taking some basic dims and applying some logic.

I deffo won't cut it for any formula one teams

The tapered throttle body been ordered

https://www.efihardware.com/products/3284/ida-throttle-body-kits


Sent from my iPhone using Tapatalk

[Eccentric shaft]

Moving trumpets. Goodness me, It's going to be half a 787B! A 393 and a half? 🤔

[Jamie R]

Moving trumpets. Goodness me, It's going to be half a 787B! A 393 and a half?

Lol all wrapped up in Anglebox, just wanna achieve max hp from the PP and broaden the torque for better drive out the corners. Without all this turbo witch craft malarkey


Sent from my iPhone using Tapatalk

[MattScott]

A little inspiration in case you are fed up with having bodywork

Sent from my SM-T825 using Tapatalk

[Jamie R]

A little inspiration in case you are fed up with having bodywork

Sent from my SM-T825 using Tapatalk

That's very quirky


Sent from my iPhone using Tapatalk

[Jamie R]

Next piece of the puzzle

New billet tapered bore throttle bodies. Fuel rails 4 x injectors. Variohm tps

Just don't ask £

[clive]

Very nice, did it come with a brain ?

[Jamie R]

Nope, just the throttle position sensor for now.

It's compatible with most popular ecu's. Haltech, link, motec etc

Just need to pick one that gives me the flexibility with the telescopic intakes.

But as that's only long and short positions, I'm using the vacuum actuator from the rx8 intake to control the lever, and that only needs 1 solenoid with 2 wires so should be easy


Sent from my iPhone using Tapatalk

[Jamie R]

Homemade stickers


Sent from my iPhone using Tapatalk