Stock rx8 ride height

Started by Grant Monkhouse, July 06, 2016, 03:11:12 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

Grant Monkhouse

Could some with a tape measure and stick rx8 at there disposal please measure how far it is from the floor too the top of the front arch please. Inches, cm, mm, furlongs, leagues, which ever measurement is easiest for you is fine much thanks


Sent from my iPhone using Tapatalk

exiled-viking

#1
I can do it but I run teen suspension and is lower,d.... and I also run low profile tyres 245/35/18 which gives me 9 cm ground clearance ...sorry not much help,, I see the chap around the block and see if i can get his ride hight

Grant Monkhouse

Quote from: exiled-viking on July 06, 2016, 06:34:46 PM
I can do it but I run teen suspension and is lower,d.... and I also run low profile tyres 245/35/18 which gives me 9 cm ground clearance ...sorry not much help,, I see the chap around the block and see if i can get his ride hight
That would be great, I was thinking of driving around and finding a car but someone might think I'm doing something dodgy stood next to their car with a tape measure


Sent from my iPhone using Tapatalk

boosted

If nobody sorts you by tomoz i can measure the stock neighbours when i get up from nights.

Sent from my SM-N910F using Tapatalk

92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.

boosted

If nobody sorts you by tomoz i can measure the stock neighbours when i get up from nights.

Sent from my SM-N910F using Tapatalk

92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.

Grant Monkhouse

Cheers Jon


Sent from my iPhone using Tapatalk

exiled-viking

he,s still out just been round to his house and his mum says he's on nights will try again tomorrow ... thanks tony.c

boosted

5 mins Grant ill have front n rear  :D
92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.

boosted

Front 680mm
Rear 690mm
from ground to arch lip.

tyres 6mm tread allround.
92 FD rx7 Twins 13.5psi.  EX Track car
EAT SLEEP ROTOR REPEAT.

Grant Monkhouse

Cheers!!!! Thanks guys. I will get my tape and have a measure of mine, I'm not sure it's lower but sometimes when out and parked up it does look lower however I haven't done the rears just yet.

I must say though the front end is different, defiantly firmer etc.

Once the rear springs are on I will get it aligned as the fronts now look to be leaning out at the top of the wheel just a tad so I'm sure I will see a huge difference and feel it once aligned and all lowering springs on


Sent from my iPhone using Tapatalk

Grant Monkhouse

Mine 673mm at front. Was expecting to be a lot lower, maybe it will drop more when the rears go on.


Sent from my iPhone using Tapatalk