Rx8 clutch and flywheel the same as an fd?

[boosted]

Lol i meant rotary car parts.

Sent from my SM-N910F using Tapatalk

[Grant Monkhouse]

Lol i meant rotary car parts.

Sent from my SM-N910F using Tapatalk

If you look closely you can see my spare engine on the floor in front of the digger


Sent from my iPhone using Tapatalk

[Grant Monkhouse]

There's also a water pump in the picture too. Found one of my EWPs in there today also. Other one is in the shed


Sent from my iPhone using Tapatalk

[boosted]

Yeppp zoomed in.

Sent from my SM-N910F using Tapatalk

[Grant Monkhouse]

Had that engine a while now and it's still as good as when I got it, turns over by hand so easily and has great chugs and puffs as it intakes and exhausts. Rather have a pile of £20 noted though than the engine lol


Sent from my iPhone using Tapatalk

[Smiffers]

This is the clutch I have

http://www.mazdarotaryparts.com/brx-7-fd-hks-twin-plate--flywheel-clutchb-737-p.asp

Probably be able too swap it if necessary. Just thinking that if I need to put a new clutch in my car I will put something better in it if I can. Plus the flywheel probably be a lot lighter too


Sent from my iPhone using Tapatalk

That is a pull type clutch so can't go into the 8, you will need to measure the pitch of those stand-offs to see if you can make a push type fit on the flywheel...  Does not look as modular as some so it might not be possible.