My badass RX7 FC cab for breaking loads of JDM, rare, aftermarket & generic parts

[rob192]

Put a list together for breaking my RX7. I\'m going to start tearing into at the weekend, I\'m still hopeful someone will take it as a whole but it\'s looking less and less likely as time goes on.

Anything marked with ** has been fitted/removed from packaging but is to be treated as brand new, done 0 miles.

Engine

Blitz Mesh Air Filter - 60
Blitz SuperSound Dump Valve - 60
Apexi full turbo back 3.25" exhaust system - 170
Godspeed 56mm twin row aluminium radiator** - 130
Winner Racing silicone rad hoses** - 30
Kenlowe 16" electric fan** - 40
Revotec fan controller** - 50
BILLION SUPER THERMO LOW TEMP THERMOSTAT** - 40
Mitsubishi Evo 8 intercooler - 40
Custom 1 piece cold pipe** - 40
Samco joiners - 20
Evo 10 rad pipe/cap used for bleeding - 30
(Can do the entire v-mount set up including the above 9 items & the shrouding/ducting for 420 delivered or 400 collected you will need to chop into the slam panel to fit it exactly as I have or get creative and work round it.)
Fuel performance 255 fuel pump** - 30
SUPER NOW RESPONSE UP KIT blanking plates** - 30
Banzai Racing double alternator pulley kit** - 50
SARD SPORTS MAGNETIC OIL FILTER** - 10
Billet oil cap** - 10
Mocal sandwich plate - 30
Mocal AN10 braided lines and adapters - 50
Mocal remote thermostatic switch - 30
Mocal oil cooler - 40
Oil catch tank** - 20
Power steering cooler - 20
Holley Annihilator 9mm Kevlar ignition leads** - 50
NGK BUR9EQP x4** - 25
FAMC stage 1 ECU manual - 100
Standard manual gearbox good condition with MX5 NA shifter & new seals etc (short throw on FC) - 100

Running Gear

HSD Dualtech Coilovers**  - 450
PMP drilled grooved discs front **
New standard discs rear**
EBC Ultimax pads all round **
Rebuilt calipers all round** - 150 the lot
APP STEEL MESH TEFLON BRAKE LINES** - 70
Cusco brake master cylinder stopper** - 30
DTSS eliminator bushes - 50 (will probably go with shell)
Front strut brace**
Rear strut brace** - 40 the pair
SUPER NOW TIE ROD END SET** - 80
URAS SUPER TIE ROD** - 100
Energy Suspension polybushes all round - (will probably go with shell)
20mm billet hubcentric bolt on spacers front** - 50

Transmission

Auto LSD - 50

Wheels/Tyres

Front - Centreline Auto Drag  15x8 ET-19 with Continental Sport Contact2 175/55/15**
Rear - Centreline Auto Drag  15x10 ET-38 with Continental Sport Contact2 205/50/15** - 600

Exterior

Jun style 70mm ABS arches** - 70
Shell extremely clean will come rolling with DTSS eliminator bushes and an Energy suspension polybush kit all round - 800 - come with the arches if full asking price met
Kouki tail lights - 70
OEM sideskirts - 60
OEM splitter - 30
Vented alloy bonnet - 50
Aero wipers - 10
6000k HIDs** - 20
Twin angel eye headlamp conversion kit** - 120

Interior

300mm Personal steering wheel - 200
Nardi Prestige gearknob** - 30
Custom leather gear gaiter** - 10
Extremely rare OEM uncut tan doorcards - 100
Momo pedals - 10
Extremely rare tan seats with headrest speakers can come with switch panel for headrest speakers if asking price met - 150


Electronics

Blitz 80mm Boost Gauge & Attain holder - 60
AEM UEGO wideband lambda controller & new Bosch sensor** - 120
Apexi AVCD boost controller - 120
Apexi SAFC fuel controller - 50
Genuine Cusco fly off handbrake button** - 10
Stack electronic oil temperature gauge (black face white lights degrees C)** - 40
Stack electronic oil pressure gauge** (black face white lights PSI) - 50
Stack electronic water temperature gauge** (black face white lights degrees C) - 40


Any and all standard parts just ask for a price. Can\'t post the big items (gearbox bonnet etc) everything else is fair game - would prefer not to post the interior parts.

Breaking will begin this Saturday. I will start taking full payments/deposits from Saturday onwards. Until that time I can still arrange a deal on the full car. Engine is toast - assume it will need either drastic rebuild or replacement.

[rob192]

Standard turbo with very little play - complete with all standard equipment actuator and uncracked exhaust manifold - 150
Genuine Muteki SR48 steel wheel nuts in gold - 40
Refurbished standard alternator - 70

[Sam.]

Whats the condition of the Exhaust?

Also the Auto LSD and gearbox?

[JohnC]

Is how is the engine? Id be interest in the bare block

[rob192]

Exhaust is in excellent used condition. Had centre box removed. Very, very loud.

Auto LSD, assume fine. No whines or clunks. Gearbox the same, also fine, engages all gears with no issues.

John, engine is :censored::censored::censored::censored:ed. If you\'ll promise me to set it on fire and film it so I can watch you can have the bare block for nout when all the rest of it is off.

[JohnC]

Ah :censored::censored::censored::censored: luck

Im guessing you put it in your project thread and I missed that.

[rob192]

It\'s actually on the bottom of this ad before the pictures as well but I won\'t hold it against you, best of luck in your search sir.

[Gee]

Hi Rob, could you PM me with your number?

I\'d prefer to speak to you over the phone as I\'m after quite a lot of parts!

Cheers!

[Prof]

Interested in the headlights Rob, are these still available?

[rob192]

There\'s only a few bits spoken for at this point Prof. Headlights are still available.

Gee, I can\'t PM you homes - you need to be a member. My number is below.

[Gee]

Brilliant cheers Rob!

What\'s the best time to give you a phone?

[rob192]

Whenever\'s clever Trevor.

[yasiryassin]

is the engine dead? thought i read on your build it had 100psi compression?

[rob192]

Engine is toast - assume it will need either drastic rebuild or replacement.

Is how is the engine? Id be interest in the bare block

John, engine is :censored::censored::censored::censored:ed. If you\'ll promise me to set it on fire and film it so I can watch you can have the bare block for nout when all the rest of it is off.

Engine\'s dead, yeah.

[juniorbamf]

hi rob, can you email me, i quite fancy the cusco brake cylinder stopper, andrewbamford1@hotmail.com
cheers.