hi how hard is it to fit a T2 engine into my S3 ??

Started by mick choi, September 27, 2013, 10:23:24 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 2
User actions

mick choi

#15
January 17, 2014, 04:00:21 PM
Quote from: shaunwil;866358You need to use a 12a cover and modify (or buy the Racing beat) engine mount. You also need to weld a oil return line somewhere in the cover.

I have a S4 gearbox with a S3 tailstock in the shed that enabled me to use the original Propshaft and not modify the gearbox pickup in the car and use the FB starter motor. This was on a S3 FB. Not sure what clutch and flywheel you would need with a TII engine though, I used a 13b EGI one, but it matched my engine.

Have a rummage on rx7club.com for more info, there is lots in the 1st gen section.

Shaun
hi m8 will I b able to use the T2  gear box with the S3 tailstock & the original propshaft ?? cheers mick

shaunwil

#16
January 17, 2014, 04:43:50 PM
I\'m not completely sure the T2 gearbox is different to the EGI one, I think the clutch plate is different on the number of Splines. I\'m sure only the earlier FC gearboxes would take the S3 tailstock. The T2 gearbox was quite different in it mounting as well.

Shaun
1994 White FD with A-spec GT3574R - 358bhp at the hubs at 0.9bar :3gears-lh
2003 Mondeo 2lt 130ps Diesel Estate Daily :driving

mick choi

#17
January 17, 2014, 05:06:29 PM
Quote from: shaunwil;871896I\'m not completely sure the T2 gearbox is different to the EGI one, I think the clutch plate is different on the number of Splines. I\'m sure only the earlier FC gearboxes would take the S3 tailstock. The T2 gearbox was quite different in it mounting as well.

Shaun

would ur   S4 gearbox  fit the T2 engine??
Print
Go Up Pages 1 2
User actions