Broke the diffuser inside the injector hole!!!

[Aliakeel]

Guys please need your help very urgent I broke half the diffuser inside the primary injector hole and I can\'t see it there I think it\'s falling inside now so what shall I do now please?

Cheers

[rx7boy]

If your 100% certain its dropped into the engine then its. Exhaust manifold off and very slowly turn the engine by hand until the apex seal sweeps it passes the exhaust port.

Good luck

[Aliakeel]

Yes I tried to the bit for few hours no luck and then last attempt it\'s gone inside and I can\'t see it anymore, you mean I take the lower intake manifold and how I turn the engine by hand?

[grinder]

I turn the engine by sticking a 17mm spanner on the power steering pump pulley and rotate it that way

[Aliakeel]

I did turn it by hand and I can hear the broken bit inside moving ,what direction I move the engine clock wise or the other way?

[Aliakeel]

I think it\'s stuck somewhere inside I can\'t turn the engine anymore only half rotor turn or less

[grinder]

that doesn\'t sound good , can you turn it the other way ?

[Aliakeel]

:censored::censored::censored::censored:ed I just turn the engine on few times without relay and it\'s sound normal now I can turn it freely so I don\'t where the broken bit gone now !I can\'t strip tue engine because of small plastic bit stuck inside.

[grinder]

as the above post , take off the exhaust manifold ( no idea if that\'s a big job .. sounds like it though )

And then rotate and see if you can see it thru the exhaust port

[rx7boy]

:censored::censored::censored::censored:ed I just turn the engine on few times without relay and it\'s sound normal now I can turn it freely so I don\'t where the broken bit gone now !I can\'t strip tue engine because of small plastic bit stuck inside.

Please tell me you didn\'t turn over the engine using the starter motor ? :xconfused

[Aliakeel]

Yes I did mate, well how I\'m suppose to take small piece plastic out ?

[Aliakeel]

So can that piece gone out throw the exhaust or just stay inside forever?
I mean it\'s plastic I know it\'s bad for rotary but is not as piece metal it might just broken to piece now.

[davehg]

You\'ll be lucky if you haven\'t damaged the engine by turning it over......

[rx7boy]

Darwin Award nominee 2013

[Aliakeel]

I don\'t have a choice guys the :censored::censored::censored::censored:ing bit fall inside the engine already and I can\'t take of the exhaust manifold or tue lower intake it\'s bit job,how to I know the engine get damage now ?