Need Help with wires. Urgent!

[unreal-icarus]

Hi,

my car is at the local mazda shop because my drive belt blew up and damaged the cables and connectors of the oil pressure pump and the oil pressure control. My car is a jdm rhd and i need a wiring diagram of a rhd car for those 2 connectors to get them repaired properly. my mazda shop doesnt have access to the wiring diagram. btw my car is a rhd 1999 jdm version. i would be happy to get ANY help. thanks!

[BenLewisMav]

http://www.rotaryheads.com/PDF/3rd_gen/Mazda%20Service%20Manuals/1993%20Factory%20Service%20Manuals/%28Z%29Wiring_Diagram.pdf

Closest you might get..

[unreal-icarus]

93 rx7 is different :/. but tanks

[BenLewisMav]

Yep unfortunately so, from my experience the wire colours should usually be the same though

[unreal-icarus]

i just had a look at my car and the connectors. the cables were ripped out of the metering oil pump connector (B1-40). the problem is the outgoing color codes in the manual match the colors of the cables that are in my car, but the incoming cables dont. B1-40 is a 10 pin connector with one empty pin, so 9 cables are coming in. i have 9, 3 directly out of the engine (blue, black, yellow) an 6 coming from another connector (blue, red/white, black, yellow, white, red) next to them. can you identify these cables? Outgoing colors are as stated in the manual: brown/white, green/black, brown/black, black/orange, blck/blue, white/black, white/black, black/light green, black/yellow.

Since the colors dont match, im not sure where to put them. i need the pin configuration of the 6pin connector and the 3 pin connector (in case there is one) of the 3 cables.

[unreal-icarus]

Anybody? i really need help with this.
for better comprehension i painted the following picture. What i need is to know if theres anything i am missing in my wiring (the big ?)  and if not what the pin configurations of the 3, 6 and 10 pin connector are.  even if your wiring colors dont match mine, i could resemble mine because i would know from where to where each wire goes (for example 3pin connector: left top to 10pin connector bottom right)