twin turbo v8 build

[jetpilot]

Interesting to see they do a swap for the 350z too, that would wake it up a bit

[tinker-27]

Hi stylus350 on FD had a aristo that we put a single on , can\'t remember which one but it worked well it was a truck turbo I think. Great motor and keeps another FD on the road and not broke for bits !! .

[rwdwiganer]

Easier to put the link here, this is the set up I\'m looking to run in my FD:
 
http://www.mkivsupra.net/vbb/showthread.php?233094-566bhp-555-lbft-on-Bullseye-S362-turbo&fb_source=message

[tinker-27]

Took the steel prop off today , just in time I think



New carbon one fitted , it had flexed around the weld !! Not quite cracked but not far off had I tried more boost or stickier tyres it would have been in bits !! .




I need some better rear tyres I think the yokos are good but no better grip than the 285 rsrs , don\'t want to run 888s at £300 + each when they only last 1000 miles tops . Going to Greg @ Protuner soon to check the base 4 psi map and try 1bar if all goes well

[Grant Monkhouse]

Any further progress on this monster after the last dyno session?

[tinker-27]

Hi I had it on Greg\'s Dyno last year , ran it at 1 bar it made 1017 bhp and 980 ft lb , it drives very well real smooth and pull so hard !!! . Because I run boost against throttle angle it\'s not stupid to drive the more throttle the more boost/ power , but the clutch has been a pain and not being consistant and not bring able to get gears , I have been on to RAM clutches who made the clutch ( to be fair it\'s only rated to 850ftlb) it\'s wrapped the centre floating plate due to spinning at high rpm-boost . I have had new ceramic plates made for the clutch which they say will hold 1200 bhp , not had chance to fit it yet as been silly busy at work but hopefully next week !!

[Grant Monkhouse]

The ceramic should be good, more likely to eat through the flywheel before they wear. As it stopped breaking things then?

[fil_auto]

Hi I had it on Greg\'s Dyno last year , ran it at 1 bar it made 1017 bhp and 980 ft lb , it drives very well real smooth and pull so hard !!! . Because I run boost against throttle angle it\'s not stupid to drive the more throttle the more boost/ power , but the clutch has been a pain and not being consistant and not bring able to get gears , I have been on to RAM clutches who made the clutch ( to be fair it\'s only rated to 850ftlb) it\'s wrapped the centre floating plate due to spinning at high rpm-boost . I have had new ceramic plates made for the clutch which they say will hold 1200 bhp , not had chance to fit it yet as been silly busy at work but hopefully next week !!

Wow Craig, just wow at those figures :Thumbs-up:burnout

Keep us posted :cool