engine plates ?

Started by adib, April 11, 2012, 08:04:36 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

Print
Go Down Pages1
User actions

adib

April 11, 2012, 08:04:36 PM
hi all.
been looking at my engine plates today and noticed that all 3 off them have a small ridge on them, its in the same place on all 4 faces. Will they be ok to reuse


its the mark right by the edge
thanks

Grizzly

#1
May 21, 2012, 07:51:47 PM
You need to measure how deap it is with a DTI Guage then if its out of Tollerance you need to get your plates resurfaced ;)
Print
Go Up Pages1
User actions