T64 Single Turbo

[SmbFD3S]

Hey all,

I\'m selling (hopefully) my Master Power T64 P Trim Turbo.  I\'m now after something different for going forward (Comparable size but flows more than a T04S) Positive boost by 2500rpm and full boost at 4100rpm (depending on your ports)

So, basically specs are:-

Compressor
0.70 A/R
64mm Inducer
91mm Exducer
4" Air Inlet
7 Blades

Turbine
0.96 A/R
74mm Inducer
64.5mm Exducer
10 Blades

T4 Inlet
3" V-Band for downpipe

In full working condition and will include the already fitted 10mm drain and AN4 Oil feed adaptor as shown on pics.

No problems whatsoever, turbine blades as seen in pics have tiny dents in them after my engine spat part of an apex seal out but this will make absolutely no difference.  No in-out Shaft play and side to side normal for a journal turbo.

This has only done 3500 miles from brand new purchased from Ed on here, and majority of the time ran at 0.8 bar.  My car was mapped on a streetport with no WI at 1.1 on this turbo and made 460bhp at flywheel.

Anyway pics below and i\'m looking for £450 + Delivery or thereabouts please

Thanks for looking.

[SmbFD3S]

New Week Bump

[SmbFD3S]

This is now SOLD