water injection help.

[FD Dave]

after managing to repair my snows water injection system i managed to lose the rataining olive inside the chassis rail through a drain hole which clamps the hose tight into the injection nozzle. Therefore i now need to purchase a new nozzle but have no idea what size i require as the calculations are all for piston engines and i dont know if its different for a rotary.

I am currently on stock turbos at 0.8 bar and running 550 primaries and 850 secondaries.  Im looking to run water only and will not be mapped into the car, i primarily want it to reduce inlet temps therefore reducing knock and also i have been told they are good for clearing out carbon deposits within the engine.

Any help would be much appreciated.:Ladys-man

[davehg]

if its just the olive youve lost (the part that clamps around the pipe when you do up the fitting) then take a trip to somewhere like pirtek...

[FD Dave]

ah good thinking my man, althought thought they dealt with large industrial hydraulic items? Do you think they would have anything small enough for my needs?

[davehg]

Yes they should do, I buy my water injection pipe from them

[bmatharu]

There\'s some really interesting stuff on AI over on rx7club. I think H Coleman is now using his PFC to run quite detailed AI maps