Turbo II boost problem?!

Started by Ben_G40, May 30, 2011, 04:06:39 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Ben_G40

Hi all,
sorry for my first post to be a question.

I\'ve just brought my first RX7 - a 1990 Turbo 2 convertible.

On the drive home I noticed that the car didn\'t seem to be coming onto boost.

When I put my foot to the floor in 3rd gear the standard gauge will only just go up to 0.

The car feels like it\'s boosting slightly but just not what I expected it to.

The power seems more linear like a NA car opposed to a turbo\'d car.

I\'ve checked all the pipework and they seem to be ok. The car seems to be running perfectly other than that aswell.

There is also quite a strong smell of petrol coming out the back which I presume to be down to it overfueling.

Any help will be appreciated and I will put up a proper first post later with an introduction.

Thanks

Ben

m1tch

Hi there! Welcome into the forum!

It might be an issue with the actuator on the turbo, the actual actuator might have fallen off the little pin that is attached to the wastegate arm, meaning that everything working, but the wastegate actuator isn\'t attached to the wastegate.

Don\'t forget to get some photos up of your car :D

TiddlesRX7

Welcome. First posts are ment to be a question arn\'t they!

As M1tch says it could well be the actuator/arm. They have been known to pop off the wastegate lever. Its hard to see when its postion. I\'ve also known the wastegate flap to stick in postion. If its stuck open then that\'d cause low boost.

Ade
I don\'t need to upgrade my stock turbo to beat your ass!

Get your finger out, get it on the road and start driving it then!!! (B.Martin 25/2/12)

antnicuk

i would also stick a proper boost gauge on it to be sure you know what its running.   What exhaust is it running?  if stock, sometimes the cat can be blocked causing richness and no boost.
400 BHP - 650 KG\'s = 616 BHP Per Ton of Rotary Power

That\'s the way to do it! :Thumbsup!


Ben_G40

Thanks for the replies!
There is quite a strong smell of petrol in the cabin aswell! I say quite it is actually very strong!

My first thoughts was to put on another boost gauge aswell. The car seems to be pulling in every gear as if it was boosting but there is no surge of power. Saying that I don\'t think the boost is anywhere near it should be!

I Will look at the above tomorrow :)

Thanks for all your help already!

Ben

yiug412

Is that a fresh petrol smell or burnt rich petrol smell?
If it\'s a fresh smell I recommend u not to drive the car. The injector seals failed on mine before and u can find quite a bit of petrol on the nice hot engine which is not safe at all lol

Louis
1984 Honda Civic EF single carb 1.4
1989 Nissan Cefiro A31 RB20DE
1990 Toyota MR2 Turbo SW20 3SGTE
1990 Mazda RX7 TII FC3S 13BT
2004 Mazda RX8 231 SE3P RENESIS!
1974 Leyland Mini Mk3 1000
1994 Mazda MX5 1.8i BP
2003 Mazda RX8 231... something with turbo.
Always put a smile on you when the \'beep\' goes on :chat

Ben_G40

it\'s burnt petrol I believe.

Update on today.
I\'ve driven it back from work and the standard boost gauge went up to nearly half way?!
Looking more likely to be a boost gauge than anything else?!
Just waiting on a new boost gauge then we\'ll see for sure.

Thanks

Ben