13B single turbo oil feed line and water feed line????

[RX4ERIC]

Does anyone one have a diagram on how to run the oil feed line on a single turbo??? I have an idea on how to run the water line, but I\'m taking advice on the proper way to run an oil feed line on a single turbo. Oil filter side for supply line and oil pan for return? Any advice would be appreciated, thanks.

[travellinbob]

I used a remote oil filter kit in my last turbo srt up and this had a take of for an oil pressure gauge and also a take off for an oil feed. the other thing i hvae done inthe past is to feed the turbo out of the oil pressure hole in the side of the block. dont know what engine ou are using, my stuff was all 12a so maybe a bit different.
 cheers, michael.

[RX4ERIC]

Thanks michael for the advice, I\'ll look into that, just trying to figure out if I can turbo my RX4. I already have the turbo from an S5 T4 60:1. Also I need to modify the exhaust manifold to fit my 1985 13B. Pretty tight squeez, I have to raise the turbo about the level of the alternator to make it work, Thanks.
:3gears-lh

[12at]

If the engine is NA then in the front plate on the passanger side there is a oil gallery which has a brass bung pressed in.. You just drill and tap it to what ever speedflow or banjo bolt you wish to use.. Also for the oil return just get a alloy weld on from like speedflow and get someone to TIG it onto the front alloy timing cover..
 
Its in the same location as a S5 turbo.. This is what i did on my 12a NA that i have turbo\'d