Santa pod today

Started by bnaellis, August 13, 2004, 06:32:37 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

bnaellis

Turned up late as I do for most meets:D
Payed £12 entry £60 to run till you pop (which with my luck with transmission not very long).
I finally made it across the finish line with out breaking anything.
Had boost controller problems with my knightsports ebs III unit.
All the boost I could make was .62 bar:confused:  Does anyone have a manual for this ?
Despite the issue with the boost it was great fun. I must run arond 20 times or so. the best time was 13.2 and the best terminal was 113 which i\'m pretty pleased with at that low boost. Friday 13th has no effect on me if anyone ever tried hard to break something it must of been me. I provided great entertainment trying to launch this thing. My rear end was bouncing like a basketball. I know my rear tyres were near on bald anyway but there is no fine line when launch even at 3,000 rpm I just sit there spinning I back off then I bog down.
Well I whooped Tim in his Purple Peril once while he whooped me about 10 times Git:reallymad.
I almost lost to a renault 5 gt turbo but 3rd gear saved the day.
And I whooped a nice looking Jap bird in  slk 320.
After a track official was telling her she\'d whoop me.
I\'ll leave Geff & Tim etc to post their times
I\'ve attached the time slip of Tim getting whooped.
I\'m 511 LC he\'s A925

gsb876

Good stuff Brian, once i get me stuff done will have a bash!!!
"Every generation has the chance to change the world"

Mills & Bains guest author :Giggle

scooby_si

ahhhh go on did anyone hit the big 10\'s ?
Glad you had fun & came out working for a change thou bud
Si

mattmaclennan

#3
.... is the suspense killing you yet?

A fine demonstration of Test and Tune for Jeff:
"how quick was that?"...
"quick"...
"more boost, that\'ll make it go really quick".

Tim on the other hand was butchering his fuel map as he\'s changed so much on the car in such a short space of time and hasn\'t mapped any of it.

I left at 3:30 so I know Jeff has the fastest FD in the country but I\'ll leave the guys to tell the rest.

Timrxmotors

My best time was 12.1,121mph.My car needs tuning.No good times,but I did log 10060 rpm in 2nd gear! I think it is run in now,250 miles when I got to Santa pod.
Geffs car is tooo powerful,11.1 best ET,and 130 best terminal.His car will definitely do a 10 sec run on Sunday.Where the hell are you Ross?
Brian never would have beat me if I had turned my lift fuel pump on,fortunately it was by only .077 secs.Never again!
:D

gsb876

Ross is in Japan dude.
"Every generation has the chance to change the world"

Mills & Bains guest author :Giggle

20B_boy

It was a good day out; every one was on top form - Tim and Brian were good entertainment as usual :rollin

Tim - did Brian beat u once then? only I dont recall him going ON AND ON AND ON about it at all!! The P/Peril will be back with avengeance I have no doubt - meaner and faster than ever. The car sounds wicked on the strip - just need to tune to take advantage of all the new stuff and stop those erroneous pops and splutters :)

Bri - mucho congrats on the successfully completed 1/4 miles. Although watching your rear end (...shut up Si!) Matt and I were convinced you were about to leave the rear end of your car about 10ft from the start line!!

Matt - very good to meet you sir! you a funny guy :wave

Geff - learn to drive - and read a feckin\' map :D
R.

maximtaylor

QuoteOriginally posted by 20B_boy

Geff - learn to drive - and read a feckin\' map :D

Oi! Bad 1/4 mile driving is my domain if you don\'t mind:rollin

Max

cpl racing

Well done Geff I hope your driving was bad because that means the car can only go quicker!

MKNoble

I\'ve got an EBS III boost controller fitted on the RX-7 I\'ve just bought.

It was working well and I had set the boost to 1 bar. However went for a run tonight and it stopped working after a while.
Now I\'m only getting just over 0.5 bar !

There is a cursor on the LED display which was permanently on when it was working and is now flashing.

When it was working I could turn it down to .5 bar and now the lowest setting is 0.6 bar.

Also do you know what the other mode is in addition to the boost gauge and boost controller modes ?

Did you have any luck finding a manual ?

Cheers,
Mike.