Wheel help please

[craicedup]

Thinking of buying a new set of wheels 10x19 +30 rear and 9x19
+24 fronts if i roll the arches and run some camber will i be able to make these fit

cheers

[SiH]

Yup, with the right sized tyres
Run a 245 on the rear, and they will fit with a roll and slight pull, possibly even a 255.
Fronts will need more like a 225 and a couple of degrees to tuck under, and a roll and pull

[craicedup]

Cheers mate thats what i was hoping to expensive to get wrong lol

[skybusr34]

if you put 42 et you can run 265 with no rubbing. so 255 on +30 is fine.  what wheels btw

[craicedup]

The wheels are ssr professor sp1\'s but i need to sell my racing hart cr\'s first ....

[SiH]

if you put 42 et you can run 265 with no rubbing. so 255 on +30 is fine.  what wheels btw

Maths is slightly off there dude.

et42 with a 265 sits about 7mm further in than a 255 on a +30, the tyre is spread over the whole rim so for width changes you need to half the difference in tyre width as it changes at both edges

So 265 et 42 is roughly equal postiioning wise at the edge of the tread to  (42 - ((265-255)/2)) =  255 et 37 Make sense?

But then it depends on the shape of the tyre wall too - some are more \'rounded\' than others.

To the OP: You will have to do archwork, but it should be restricted to just a roll and possible small pull.

[skybusr34]

The wheels are ssr professor sp1\'s but i need to sell my racing hart cr\'s first ....

are these in 19" any pics

[craicedup]

yeah mate they\'re 19s cant post pics though if you have an email address i can send some pics to you.

[skybusr34]

mgharris2182 at yahoo.co dot uk    cheers bud..   just thinking were these off a black 99 spec ?

[craicedup]

yeah thats the ones thats my motor.

[skybusr34]

post me over some details dude??

[craicedup]

Details sent mate.

[Dan Norton]

Post the pics here.....19" SSR Profs = a massive win!