BIG problem

Started by VSRX7, October 05, 2009, 10:31:19 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

VSRX7

Hi all
 
I need help . Problem- rpm revs only to 3000 on each gear on neutral to 8000 when I accelerate on any gear stay under 3000 rpm and not goin more. I reset battery not help what can be the problem ? In week time I\'m changing ecu for pfc. WHERE ALSO CAN BE THE PROBLEM ! PLEASE HELP

philiwily

Could do with more info, modifications and does it idle ok.
Sticking a PFC in isn\'t going to cure it. Check the map sensor hose hasn\'t popped off.

Jit

its in limp home mode. Probably because your stock ecu has thrown an error code. You need to find out which code it has thrown either by putting a mazda diagnostic tool on it or by pulling the code yourself (there is a how to on the net somewhere for the FD).
Then look up the code and solve the problem. Common codes on FDs are those for the oil metering pump and also for the rats nest solenoids

bin liner

sounds like omp as mentioned...if u have a power fc with the commander you should be able to check....
Definately want it mate but the dog has just died so will be getting the missus a new dog for christmas....
Sounds like a good deal but will have to ask the dragon first.....  :flamed  :spank

m1tch

Quote from: bin liner;646160sounds like omp as mentioned...if u have a power fc with the commander you should be able to check....

I agree, might just be a sensor on the OMP that has gone meaning that the ECU goes: EEEEK! no oil! and puts the car in limp home mode, check the error codes :)

VSRX7

Thakns guys! at the moment car it\'s a part. I need to fit intercooler and radiator (I will keep stock twins at the moment  :Giggle) , few gauges to connect , and power fc to connect , and finding the problem . Can I check this problem other way then going to daiagnostic place?
 
I will let you know what was the problem !

matt p

No mate, the way as has been mentioned is to pull the codes from the diagnostic port.

You need a small diode from maplins and bridge the two ports TEN and GND

It will flash, short flash then quick flashes......so it will read as follows.

3 short flashes will mean 3
5 quick flashes will mean 5

So the code will be 35 :)

There is a list somewhere on the web which what each code is, ill try and find it.

Regards

Matt
Why its good to do your homework of "specialists"

http://www.fduk.org/forum/showthread.php?t=28429

matt p

Wooooooo i was right, my memeory is getting better lol!!

http://www.fd3s.net/engine_codes.html

Just follow the above link dude, think the L.E.D diodes are £1 from maplins.

Matt
Why its good to do your homework of "specialists"

http://www.fduk.org/forum/showthread.php?t=28429

VSRX7

Thak you very much for your help Matt P :)

matt p

No worries dude, hope you get it sorted.

If you get stuck throw another thread up :)
Why its good to do your homework of "specialists"

http://www.fduk.org/forum/showthread.php?t=28429

VSRX7

Sorted :) more fuel in the tank:)

VSRX7

Replaced fuel pomp for bosh one and all gone:)
 
Thanks guys:)