non sequential vacuum hose simplification?

[MaLicE]

ok i snapped a solenoid, had an ask about and got sent a link to rx7 club showing vacuum hose simplification diagrams... anyway as im running non sequential i found this diagram....



has anyone else done it?? atm i still seem to have 90% of the rats nest and this simplification deletes most of it...

anyone done it? as far as i can see its the same for a single turbo conversion... but they say it works on rx7 club...

[nuki]

i thought you had to keep the purge controll solenoid to stop a constant buzzing noise from near the upper inlet? i know someone using a setup like this one.

[philiwily]

I dont have purge control and never had any noises, nuki I think thats a simplified sequential setup.

[nuki]

yes it is i just thought it might make things abit more simple than looking at the stock diagram lol

[MaLicE]

well its not exactly connected to anything else so i could connect the purge solenoid to the catch tank thing and to the carbon canister...

[nuki]

the purge control solenoid might only make something beep if your ECU is stock..? not sure.

[MaLicE]

im running power fc...

[Looney]

Any one know what resistors are needed to fool the rats nest plugs into thinking that they are plugged into the solonoids?

I read somewhere I needed 300 Ohms resistors, but trying to search for them seems to make them elusive. Plus I can\'t find listings of resistors in ohms.

[MaLicE]

if you are running power fc you just turn the sequential feature off in the menu...

i thought it was 32ohm