help smoking apexi ecu

[barry798]

got car finally running after 18 month, fitted new engine harness had to modify a 1992 loom but arfter running it for 5 min gave it a few revs then cut out and apexi ecu started smoking bad stuck the mazda ecu in and run but lumpy but idled ok any body had any probs with this ecu
unable to upload pic

[clive]

As you have found the stock ECU will at least start your single turbo but the fact that it didn\'t fry it indicates logically indicates a fault with the Apexi also I know how patiently you checked out the loom,

[barry798]

just warried putting a new apexi on it might do the same ,whots the cheepest place to get another ecu

[rx7ben]

I got mine new from ebay mate. Cost about £500, thats the cheapest i found.

[barry798]

you dont have a link or contack do you

[rx7ben]

Have a look here mate, but thay gone up in price alot since i got mine.
http://shop.ebay.co.uk/?_from=R40&_trksid=p3907.m38.l1312&_nkw=rx7+apexi&_sacat=See-All-Categories

[jackaleks]

pop open the fried Apexi and see if it can be fixed? if it\'s dead you might as well try...

[barry798]

spock to wgt and he said by the sound of it looks like a new one, do have a pic but unable to upload, found the problem the new injector i got from reworx to go in the exssive lower manifold 550cc were to low ohm "think" chris said they were 7 and sould be 14 i think somthing like that any way , dear way of finding out i need resister

[chris]

sounds like the injector driver is fried, you may be able to just replace the driver if the board has not been toasted.

[barry798]

going to give pip a call next week when he gets back from holiday,think he repaires them no harm in trying