New stainless steel straight through exhaust.

[Brett]

Anybody know where I can get a stainless steel straight through system?  My old custom system was mild steel and its got about 3-5months left by my reckoning.

 So any reccomendations?

[sadgoth]

racing beat do a nice one, as do Apex\'i depends on what you want and how much you want to spend.

[Brett]

Not really worried about cost, the last one was £850!

[20B_boy]

What do you want to make power-wise in due course, and how noisey do you want it to be/not to be?

[Brett]

Short of putting in a new ECU (Which I\'m looking at now thank you Microtech and Pip!) the car is already at its max in terms of power.  (Intake and exhaust porting all been done, uprated fuelling and oil system, decent air filter etc...)

 My current exhaust is as follows:- 2x 2.5" pipes leading from each port.  Join roughly halfway down the car into a single 3" pipe, then splits through a 3.5" Y piece into 2x back boxes with about a 2.5" bore at the end.   Its a pretty good system, its loud, but not defeaning (unless you following in a drop top), only problem is a reverb\' at about 3k rpm.

 Only looking to replace it cos of the rust, so if I can get a complete sports system (stainless) off the shelf then I\'ll go for that.  If not I\'ll get another custom one made up in stainless.

[Brett]

Just to point out b4 I forget my car is N/A.

 We dont like none o\' that turbo stuff in these parts! :bandit