My Rx won go over 0.5 bar =(

[Laursdahl]

Just godt my RX started up today.. i was having trouble starting it (it has been standing still for severel months) I pull the plugs out and disconnected the fuel relay and ingnition aswell. then cranked the engine lots and lots of fuel was in the engine.
Back in with the plugs and I finally got i fired up (LOTS of smoke) an let it run for a while.. I carefully took it for a drive and after driving some time i wanted to give it a real spin.. But this is where my problem started.. When it boost\'s approx 0.5 bar the engine completely stalls.. then a second or to later it bangs out of the exhaust.. it\'s like it cut\'s the ignition after 0.5 bar..

The engine I almost stock apart from the Pan speed ECU and some Hardpipes + IC.

Does anyone know what could be wrong?

-Thanks

[Jono FD3]

did you have any issues before you put her away??? has it always had this ECU?? sounds like your hitting fuel cut for some reason??

Jono

[Laursdahl]

No, no problems before... And it always had this ECU...

[BlitzBoy]

check the vacuum line to the map sensor

[Laursdahl]

Where is this located? this is my engine bay:

[Jono FD3]

it\'s on the bulkhead just above your oil filter.... it\'s just over 1" square, held with 1 10 mm bolt and has a boost pipe going to the bottom of it & a multy plug to the side

[Laursdahl]

They look fine :mad: