Brake Disc Position

[FD3UK]

I am in the process of making some bells to fit my brake kit.

The std disks are set about 50mm inside of the hub face, I have made a sample bell which has the disc level with the hub face. This brings the caliper much closer to the wheel spokes, mostly because it looks good.

I am looking for opinions as to the possible problems with this setup?

[antnicuk]

the only problem will be wheel clearance of the caliper,  you may have trouble getting a deep dish wheel to fit.  When i did mine, i built the whole set up on the bench with the upright, hub etc and the wheels i was going to use, then you just make it all to fit as needed. I see no issue with having the disc further out, most new performance cars have minimum clearance between the wheel and caliper although FWD cars tend to use higher ETs.

[FD3UK]

Caliper clearance is fine with the wheels I have, but maybe I will be restricting my choice