Street Port - Re-use??

[DMDRIFTING]

Hello,

i have a worn 13b with low compression results, drives ok, starts with a bit of fuel/flooding smoke from exhaust.

It has been street ported and all i would like to know is can the Street Ports on this engine, be used again? If i were to have this rebuilt now. (Obviously before it goes pop)?

[antnicuk]

yes,  unless the plates are worn beyond use.  the same goes for the rotor housings.

[hairyhoover]

if they are slightly worn the plates can be lapped to give a new lease of life

[DMDRIFTING]

Thats good news, just got it back from REWorxs and Geoff said the same. Its not worth him mapping as it might have a sticky or chipped seal. But going to get  a run around for work and  get  it to him got a rebuild while its all ok!

Thanks for the replies