Off to Super 7 Autos tomorrow...

Started by Rotaryguru, November 07, 2008, 06:06:08 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Rotaryguru

.. but I forgot to ask what the address is!!!

Anyone know the Postcode for the workshop? All I know is that its south of Gatwick.

Help please! :cool

shaunwil

1994 White FD with A-spec GT3574R - 358bhp at the hubs at 0.9bar :3gears-lh
2003 Mondeo 2lt 130ps Diesel Estate Daily :driving

Rotaryguru

Aha! Thanks, I couldn\'t find the address on the website anywhere..:3Confused

Need to look a little bit harder next time...  :Hammer

Jit

ooh might see you down there then! need to pick up a few bits tomoro!

Timmy

It\'s on the road between small dole and upper beeding, oposite the petrol station. If you got a low car you need to take it very easy getting over the hump at the entrance, but it\'s easy if you go diagonal across.

benRX7

just out of interest do they do sympathetic mots?

Rotaryguru

Quote from: Timmy;552030It\'s on the road between small dole and upper beeding, oposite the petrol station. If you got a low car you need to take it very easy getting over the hump at the entrance, but it\'s easy if you go diagonal across.

Thanks, the car is ultra low, I struggle with most speed humps. :2Mad

I\'m not having much done, just a service. Would be nice to be bolting on some better bits, but alas, no money...:(

Timmy

Mines very low to, you just need to go to the far side and go over diagonaly. It\'s not really that high just you don\'t really see it so you need to know it is there.

Nik da Greek

I learnt from da Man himself that if it spins up in first between the really rough bit of entrance road and the last speedbump at the gate, then your secondary turbo/switching system is working fine! :D Top tip, pop pickers!:Thumbs-up

Good luck wi\' it, mate, like Timmy says, the first speedbump is a killer!

Wotcher, Jit, ta for the boost gauge, dude, haven\'t had time to try it yet :(

Rotaryguru

Had the car serviced at Super7, and it is now running a dream!!

All the oils and fluids were changed, and a compression test. My figures came back hi 6\'s on the front and low 7\'s on the rear rotor. So am really pleased with that. The car is completely rust free, and a very clean example underneath!!

Jason and Chris are really great, and were ultra helpful, definitely would  recommend their work to anyone.

The drive home was great ;):3gears-rh

shaunwil

1994 White FD with A-spec GT3574R - 358bhp at the hubs at 0.9bar :3gears-lh
2003 Mondeo 2lt 130ps Diesel Estate Daily :driving

Jit

good to meet u there dude...sorry we couldnt stick around long :(

Nik da Greek

Just like the Lone Ranger "who was that mysterious masked man" :D

Gald you found it ok, Lachie, hope my rubbish directions didn\'t get you too lost. And that the guys sorted you out well, you always get top work off them :Thumbs-up

Rotaryguru

#13
I was a little late, but only because of traffic getting out of London, your directions were spot on Nik!:Thumbs-up

Good to see you there too Jit, can you send me an email RE: those speaker covers. rotaryguru at hotmail dot com