heater/blower

Started by vonrumble, October 16, 2008, 03:46:02 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

vonrumble

How do you change the heater motor on an n/a FC? just need a rough guide.

m1tch

Isn\'t it located in the passenger footwell? I seem to remember when I was running some wiring over that side, when I took the panel off (the footwell blower on the passenger side) there was a white plastic thing lol I think thats it :)

pdtaylor18

#2
Correct, the blower is in the far left hand corner under the dash and is held in by I think 3 or 4  x 10mm nuts. Its not too bad to get at but sometimes taking the glove box out can shed more light on the whole thing but it can be done without. Take it yours is goosed or just noisey ? If you have aircon then there is also a clamp which is only a quick release and if you have not got aircon then a plastic air duct tube which again is clamped. Think at the matrix end of the duct is a little grommet, its only a push in type but needs to come out.
1990 TII Cab JDM- Lambo Orange- HKS GT3037 turbo,Apexi PFC and datalogit,Greddy FMIC,Trust coilovers,18" Antera 10J 265 rears, 18" 8.5J 235 fronts

Paypal: pdtaylor18@hotmail.com
Email: pdtaylor18@hotmail.com

Pete[SIGPIC][/SIGPIC]

vonrumble

totally gone, just hoping it will do the trick replacing it. checked all fuses etc nothing blown so fingers crossed, thx for the advice.

pdtaylor18

If you need a heater/blower then i have several if you need one.
1990 TII Cab JDM- Lambo Orange- HKS GT3037 turbo,Apexi PFC and datalogit,Greddy FMIC,Trust coilovers,18" Antera 10J 265 rears, 18" 8.5J 235 fronts

Paypal: pdtaylor18@hotmail.com
Email: pdtaylor18@hotmail.com

Pete[SIGPIC][/SIGPIC]

m1tch

im pretty sure pete can build a brand new FC out of all the bits you have in your garage/dining room/loft lol :D