MAROBI or EPROM chip

Started by McPie, September 25, 2008, 03:50:58 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

McPie

Has enone tryed it>??

any way I confuce where to install it

there as shown in picture


or



thanx in advance for the answers
Doc at your service...
if your rotor doesn\'t work, try to seek for problems in washing maschine centrifuge...
929 + RX7 = RX4 powered 13B TURBOII

Prof

I recognize the top pic - all the ECU\'s for the FC that I\'ve seen look like that one - I don\'t recognize the bottom ECU - what car is that off ?
 
Your chip will almost certainly replace the eprom on the board - part number will be something like 27128 / 27256 - maybe with a letter in between 27 and the latter part of the number.
"Plus this engine is probably one of the most volumetric engines going! It passes more air than a herd of cows eating vindaloo\'s" - courtesy of AtomicRex


McPie

yea it replace  27256, so I put it in right place

time to check how it works...
Doc at your service...
if your rotor doesn\'t work, try to seek for problems in washing maschine centrifuge...
929 + RX7 = RX4 powered 13B TURBOII

McPie

so....

engine start very nicely, exhaust sound looks a little bit diferent, but most importatnt

all the year I had a bug wich after 10 minutes makes fuelcut or boost cut
any way only way to go forward fast is to turnt of and turn on ignition just 1s and you are ready to go again...

know then problem is gone. But after 17min I turned of the engine waited for 2 minutes and started again. I found that ECy think that engine is cold and again keeps for 5minutes 1200RPM

so propably my termo sensor is dead...
Doc at your service...
if your rotor doesn\'t work, try to seek for problems in washing maschine centrifuge...
929 + RX7 = RX4 powered 13B TURBOII

Brett

Glad you got it sorted - the idle problem is fairly common :)
Brap Brap Brap Brap

McPie

what do you want to tell me mr. Brett?
Doc at your service...
if your rotor doesn\'t work, try to seek for problems in washing maschine centrifuge...
929 + RX7 = RX4 powered 13B TURBOII

McPie

Doc at your service...
if your rotor doesn\'t work, try to seek for problems in washing maschine centrifuge...
929 + RX7 = RX4 powered 13B TURBOII