How do you remove the tail lights and side repeaters?

[jonny116]

Does these simply pull off or is there a screw or anything hiding?
 
Thanks
 
Jonny

[batman]

open the boot three screws on top of the light covers faceing  up in the air then remove the center section cover all on top  then carefully with a big flat screw driver go in behind the cluster and apply a quick pop of force and they pop out backwards center light is  screwed in think its four phillips can do pics if needed

[Matt_K]

Undo the screws and slide the rear lights out to the side

[jonny116]

ahh genious thanks for that!    They have faded a bit and look slightly red in places, im going to re-tint them tonight if i can.

[RedRummy]

FD rear lights slide out to the side away from the car.... might need a bit of welly

Side repeaters (on front wings) need to be pushed forward towards the front bumper, (or is it backwards LOL) then they pull straight out.

[RedRummy]

aaahhhh.... so THAT\'s what that little lid with "OPEN" on it is for... LOL

Undo the screws and slide the rear lights out to the side

[Ada7]

Was going to ask this myself but now dont need to
On with the 99 specs now

Adam

[Hi RX7]

Thanks for that I\'m in the process of putting some red led\'s in and could not figure out how to get to the bulbs replaced

[SleepyDude]

When i first tried to take them off took me forever, carefully pulling and pushing trying to get them off ended up getting a little annoyed gave it a swift palm on the inner side and off it came. LOL

Tbh i was dreading getting them off again to replace them with new ones in a few days time.

[FD3S Efini]

im looking at spraying my inner lenses, i know how to get them aout and seperate them but what would you use and how would you re-seal them?

[tubbydeuce]

when i took mine off i had to keep checking if there was a rogue screw id missed. it took quite a big tug to yank them lose so be carefull you dont damage paintwork or drop them when they finally give.

[anees]

well for tailights... there are two screws.. unscrew them slight them to right for right and left for left and there u go...piece of cake