Rats Nest Refurb.

[Cleggy]

I\'m in the process of doing the rats nest vac hose refurb job and as I expected I\'ve managed to brake two different solenoid valves nipples.
 
The ones I\'ve snapped off are item J and item A in the image at the link below (shamelessly taken from rx7club.com).
 
http://www.rx7club.com/attachment.php?attachmentid=249277&d=1185052373
 
I\'m rebuilding with stock twin turbo\'s and a PFC, I\'ve resigned to the fact that I have to at least replace item J but being as I\'m deleting the airpump and ACV I\'m thinking that Item A can just be removed?
 
The index just says A is a solenoid valve: pressure regulator but doesn\'t state for what. I\'m assuming it is for the ACV which I\'m removing.
 
Any info would help.
 
Cheers.

[Fish]

That link dont work. Which ones on this one?



Fish

[Cleggy]

Item J and item A in the index- it\'s pretty much exactly the same diagram as the one in the link.

[Cleggy]

Bumpity bump...

[m4drx]

i think i have A mate.

m4dsup@hotmail.co.uk

let me know if you need it.

[LeedsLad]

i was under the impression that the pressure control solenoid connects to the fuel pressure regulator but i could be wrong, the airpump is not connected to the rats nest it is operated by a magnetic clutch that dissingages at higher rpm this is controlled by the ecu

[Cleggy]

Cheers for the pointer Leedslad- I downloaded the service pdf\'s (not the manuals) and had a good read.
Its a pressure regulator for the hot start system, nothing to do with the ACV. It helps prevent hot start vapour locks and stabilise idle speeds on hot starts also.
 
M4drx- will let you know about the solenoid tomorrow as I may have secured a whole rats nest and solenoids (just incase I brake anymore....)

[Cleggy]

M4drx- email sent..........