turnin engine over by hand and solid HELP!!!!!

[Drag Emperior]

How easy should this be, can you expect to feel much resistance
when turnin it over. Cause I have a 19mm socket on bottom pully and standing on it and engine donest turn :reallymad

Help plz

[maximtaylor]

You\'re fighting the compression cycle. Take out the trailing plugs (top ones) and it\'ll turn and go psshhht, pshhhht!!

Max

[Drag Emperior]

I have both sets of plugs removed and she seem pretty dam
solid to me :confused: :reallymad

Anything else you can suggest

Cheers for the help

[MikeLMR]

is it out of gear ? (someone has to ask the daft questions )

[Drag Emperior]

Gearbox is removed:confused:

[tsh]

Carbon lock? Will it turn either way (Don\'t unscrew the bolt!).

If bad things have happened, solid stuff can jam the rotors as they try to spin. This can happen with just lumps of solid carbon, not necessarily spare bits of metal.

Sean

[Drag Emperior]

It did move a wee bit at the start, then i took the plugs out
it seem to jam solid, if it is carbon build up how do i get round
this prob without strippin her.

[Drag Emperior]

Found the problem, i took off the exhaust man. and got  water in both rotor housing, any ideas how the f**k it got in there

[Drag Emperior]

Another Pic

[Drag Emperior]

Sorry for the fuzzy pic

[g11ary]

If you have water in there then the water seals have probably gone and its rebuilding time.

[Drag Emperior]

What is the best way to get this cleaned out:confused:

[Drag Emperior]

If you have water in there then the water seals have probably gone and its rebuilding time.

Dont think it is water seal, cause it is water not coolant and the level didnt go down. Any other ideas

Cheers
Uel

[MikeLMR]

have you removed the inlet manifold ? if you have the water in the manifold heating has probably drained into the inlets ? (if the the 13BREW has the same setup as earlier cars that is)

mike

[Drag Emperior]

Inlet did have a little water but not very much, wat does this mean cause im confused