bush fitting advice

[Adie Moore]

i\'v purchased a set of powerflex rear bushes and am in the process of fitting them, actually i\'v not got very far! So i\'v removed the trailing arm fine and i\'m now on the track controll arm, this is where the problems start. I\'v removed the bolt nearest the wheel but the arm is still held in position by the pillow ball (?) bush. I\'m not replacing these so i dont want to knacker it and it looks like it will be the same problem for the upper arm, outter most bush ( also pillow ball?). How can i get these out?

cheers adie

[Spartacus]

Not sure what you mean but there is a bolt that runs through the pillowball bushes so if you remove it you can take the arms off.

[Spartacus]

drop us a pic if you can.

[Adie Moore]

cheers for the response, but it was just me being a pussy. it was old and didn\'t want to move.

[Spartacus]

cheers for the response, but it was just me being a pussy. it was old and didn\'t want to move.

Much like myself:rolleyes: Old, that is:eek:

[CraigWWW]

Why dont you take some pics of the different stages of fitting... i would love to have a guide as Im doing this soon myself!

[Spartacus]

There is a good guide here http://www.rx7club.com/showthread.php?t=211372

[Adie Moore]

ok i\'ll go and take some photos, first though i have another problem...as a continuation from my first problem, all the bushes have now been changed,and i\'v come to put the suspension back on the car. The control arm i had problems with getting off, i now canot get back on. It was tight in its location in the hub, hense my difficulty in removing. I can now see why it was tight, as the two bits of metal it goes between are slightly closer together than the length of the bush. I dont have any access to specilised (sp) tools so, what do you thunk?

[Adie Moore]

balls, cant post pics as my membership has ran out.