AAARRGGHH - B@#!*$D Interior.......

Started by RussH, January 16, 2008, 08:58:21 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

RussH

Before I loose my rag and break something, is there a knack to removing the plastic shroud around the instruments. I\'ve removed all of the screws I can see so that the bottom is loose but the upper part is rock solid. :confused:
 
Short of putting my foot on the dash and yanking hard and possibly breaking a load of clips, I\'m not sure where to go next.
 
Any ideas?
 
Cheers
 
 
Russ

batman

if your talking about the speedo and rev cluster thats all it is remove the screws underneath were the nut ball blower is and take off the side trim near the check strap there s a screw in there to remove the ball blower panel then gently prize the binacle away from the dome and it comes forward towards the steering wheel failing that use a screw driver underneath and lever left side and right side alternatly should come off
REAL MEN PLAY WITH TWINS     :Laugh

batman

REAL MEN PLAY WITH TWINS     :Laugh

karl_tate

is in a FD??
 
i had struggled the first time doing it, two screws either side at the bottom as above and i just lifted it up a bit and pulled forward, dont yank though or you will probably break the clips.
____________________

Built In Japan - Built Better In The UK

XBOX GAMERS TAG --- tatey1985

RussH

Hey...ascaudio to the rescue again!!:Thumbs-up
 
Yep it\'s am FD.
I\'ve removed all the screws as described and pull towards the steering wheel but it doesn\'t budge.
 
Where does the binacle come away? Near the front edge at the split line or near the windscreen/demist grill?
 
Cheers
 
Russ

karl_tate

i couldnt get mine out and i thought i was going to break it. it comes away from near the screen. keep pulling it will eventually come away, lift the whole lot up a little bit as well
____________________

Built In Japan - Built Better In The UK

XBOX GAMERS TAG --- tatey1985

RussH


Jono FD3

When you take this out you will be removing the clocks, clock facia & the dome on top that sits on the main dash structure..... basicaly all you do is unscrew the 2 retaining screws underneath, then gently pull the cluster towards the wheel.... you might need to give it a little wiggle, then you will hear a click, then the whole thing can be pulled forward to disconect the wires.

Jono

batman

the dome is seperate to the facia rus be firm but gental it ll come appart and your welcome
REAL MEN PLAY WITH TWINS     :Laugh