help!!! vacume hose

[piggy]

i\'m looking for vacume hoses diagiam for 92 fd3

[Fish]

Fish

[piggy]

hi, is it for a 1992 fd3s?

[Bobbit]

yep, i\'ve used the exact same one myself many times and i run an 92 fd

[piggy]

is every diagram for 1992-1998 all the same? or is there some difference between some of them in different years??

[SmbFD3S]

is every diagram for 1992-1998 all the same? or is there some difference between some of them in different years??

Out of Interest why would you need to know this if you have a 92 FD???
 
I\'ve also got a 92 UK FD and used this diagram to replace the hose and is all ok.

[piggy]

But after i opened up the top, I realized that i can not find the pipes for section C, or D, not sure which. it\'s not there. is it possible that it is in a place that is hard to find? or is it my car\'s problem?

[gmogle]

I think you\'ll find some of the hoses will be missing on your car because it isnt an American FD. The diagram above is for an American one.

But yeah, should be similar and give you a heads up on the vac hoses. Good luck with it and take your time !!!! Remember when I did mine I was shocked to find how many werent on tightly, were split or the 1 way valves were both way !!!!

[SmbFD3S]

As gmogle says, due to this being from an American model (and american site originally) there will be some differences, but the majority will be the same... They have different emissions laws over there....
 
Are you checking the system or replacing the hoses?
 
If replacing the hoses just take it step by step and take photos of what you remove so if you get stuck you have something to refer back to. A good guide on this procedure is found here:
 
http://www.rx7.voodoobox.net/howto/vachose/vacjob.html
 
I think a lot of us on here have also replaced the check valves for these:
 
http://cgi.ebay.com/ebaymotors/RX-7-93-95-DURABLE-VITON-Check-Valves-set-of-4-FD3S_W0QQitemZ290179079952QQihZ019QQcategoryZ33742QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
 
Hope this helps

[piggy]

its have some kind of hold back at around 4k to 6k rev. checked by other mate, and said there should have some V. pipe missing or in a wrong place, or can be the one way valve fit other way round!
this is the reason why need to have a good look at it.
chees

[SmbFD3S]

Is it a standard car ?
 
There are hundreds of threads on here about the dreaded hesitation at 4500rpm matey, just do a search and you\'ll see and prob will find your answer :yes
 
Could also be an earth issue depending on the age and condition of the car.... Mine was due to both, i cleaned up ALL the earth connections and replaced ALL the vac hoses and changed the check valves for the Viton ones and it cured the problem :cheers

[arrouk]

i think the diagram on garrys site is the right one, i think the only differance is the egr valve. or do a search and its here, taken from the first thread.

matt

[piggy]

thank\'s for every one advise