Pics with new bits fitted...

[m4drx]

guys do you mind if i ask where you got your lights from and how much you paid.  i have been looking for ages now

[Bulla]

We both got the lights and covers from Newera, forget what they cost now but not cheap, but then FEED never is. If I remember correctly the lights with the covers were just over £300.

[m4drx]

Bulla, how much did you pay if you dont mind me asking

pm me if you like.

im searching thier website as i have done before but with no joy

[probedb]

Ahem....about £320 all in....expensive but they look sooo much nicer than the 99-spec ones on that bumper

Colin, the exhaust is from SMB in Australia (all stainless, 3" piping with a 4" titanium tip) and the sills are from shineauto. They can be bought through Gary @ RotaryArt now. They\'re basically just screwed underneath....I\'m not 100% happy with where they\'re sat but when Kev fitted them we couldn\'t stand back and see what they were like so might get Kev to move them at some point

[Bulla]

Bulla, how much did you pay if you dont mind me asking

pm me if you like.

im searching thier website as i have done before but with no joy

You need the Type II R Bumper as well to fit them.

[m4drx]

i have one but no idea which one as i cant tell the difference!

pants.

not sure now what will fit 99 spec or feed

[craig]

nice looking good

[probedb]

i have one but no idea which one as i cant tell the difference!

pants.

not sure now what will fit 99 spec or feed

It\'s easy to spot, the Type IIR is more curved along the bottom of the bumper than the Type II....hopefully this shows the difference....you can see it in the red circles and also the bottom of the IIR is curved upwards in the middle....pic has Type II top pic and Type IIR bottom pic.

[m4drx]

It\'s easy to spot, the Type IIR is more curved along the bottom of the bumper than the Type II....hopefully this shows the difference....you can see it in the red circles and also the bottom of the IIR is curved upwards in the middle....pic has Type II top pic and Type IIR bottom pic.

THANK YOU!  :cheers :Laugh

ive been trying to spot the difference but my plan was to measure the 99 spec lights against my bumpr etc, anyhoo looks like i have the type II

No more feed lights then :rolleyes:

saves me a bundle though.

thanks for your help mate. will post some pictures after the car is complete.

(bumper, lights, bonnet, wing, wheels)

Tharek

[probedb]

Glad to be of service

[Colin]

Colin, the exhaust is from SMB in Australia (all stainless, 3" piping with a 4" titanium tip) and the sills are from shineauto. They can be bought through Gary @ RotaryArt now. They\'re basically just screwed underneath....I\'m not 100% happy with where they\'re sat but when Kev fitted them we couldn\'t stand back and see what they were like so might get Kev to move them at some point

Thanks, great looking car!:Thumbs-up

[hairyhoover]

Hi, i am just about to get a set of kei d1\'s 18x8.5 18x9.5 like urself what offsets did you use?

[probedb]

They only come in 1 offset for each wheel size....fronts (8.5) are 32mm and rear (9.5) are 35mm and they do look nice