Whats this in my turbo oil feed??

[benRX7]

Anyone know what it is and why its there? Its like a brake line dome but threaded in the centre.
Can I just fit my normal feed flange with restrictor on top of this? Should I try and pull it out? Or finally if I can`t do either where do I get a feed fitting to work with this?

[kev-yorks]

Its a restrictor pill don\'t take it out as you would over oil the turbo forcing oil out of the seals.
Kevin

[benRX7]

Are you sure, Its a lot bigger than the restrictor I normally run, and would be running on this. The only difference between my old and new turbos is this new one is ball bearing

[kev-yorks]

The turbo manufacturer knows what oil flow the turbo needs. Ball bearing turbos actually need less oil than a plain bearing type as in a ball bearing set up the oil is for lubrication only in a plain bearing set up the bearing is actually supported by the oil in the journal.
Kevin

[benRX7]

Yeah I know they need less oil but that contradicts the fact that this restrictor is bigger (flows more oil) than my old Journal bearing restrictor, I`m confused (doesn`t take much sometimes)

[kev-yorks]

Just trust the guys that built the turbo if you start messing with it then any warranty would be invalidated or if still unsure give them a call.
Kevin

[benRX7]

Ok cheers mate

[banned advertiser]

It might be a smaller restrictor, but if the turbo is bigger it will have larger bearings so possibly bigger hole in restrictor.

[clive]

Hi Ben,

One tip for you,  make sure the oil drain pipe is at least the internal  bore of the drain hole on the engine with no kinks in the pipe, as I have known people get this wrong and then the oil backs up into the turbo because it can\'t drain properly and the engine smokes.

Converted, 7 or 8 FD\'s now with different sized Turbos and never had a feed problem where it\'s needed either increasing or decreasing.

Please just screw the fitting in and leave it alone:WaveBye .

[benRX7]

Unfortunatley it didn`t come with any fittings thats why I`m not sure what to put on there. Turbos a T51R if that gives any more clues
 
The drain isn`t a problem I`ve made up lines that are the same as the hole in the block so thats sorted

[kev-yorks]

Any turbo supplier will get you a flange or there are plenty on ebay.
Kevin