Power FC Commander "Monitor" Q\'s

[antnicuk]

I have an ewp with controller, but i let the water temps sit at about 80 -83 cos if its too cold the choke doesnt go off fully (although mine is now disonnected).  I can adjust it down for the POD etc.

[Iwan]

Originally posted by maximtaylor
The air temperature sensor is on the underside of the intake plenum.

It is possible to adjust the temperatures at which the fans come on via datalogit (don\'t think you can do it on the commander), but perhaps a better method may be to have an override switch to put the fans on manually.

Regards

Max

g\'day,

just turn the A/C switch on, this should bring up the blower. Your temp will sink. I highly recommend to turn on your A/C while sitting in traffic.
Just tested it yesterday, while going home after party.
Mods:
Koyo ALU rad, 2 Layer 53mm core,
lowered A/C cooler in front
PFC
going about 200km/h for about 10km will bring the temp to 90-93°C, by turning the A/C on, the temp will drop to about 80°C.
Same due to city traffic. Without A/C temp= 90-93°C, with A/C on: temp=79-81°C

REgards
Iwan